Related papers: Performance Analysis and Optimization of Network-A…
This paper considers a multiple-input multiple-output (MIMO) receiver with very low-precision analog-to-digital convertors (ADCs) with the goal of developing massive MIMO antenna systems that require minimal cost and power. Previous studies…
The wide bandwidth and large number of antennas used in millimeter wave systems put a heavy burden on the power consumption at the receiver. In this paper, using an additive quantization noise model, the effect of analog-digital conversion…
Distributed optimization has attracted lots of attention in the operation of power systems in recent years, where a large area is decomposed into smaller control regions each solving a local optimization problem with periodic information…
A multicell-coordinated beamforming solution for massive multiple-input multiple-output orthogonal frequency-division multiplexing (OFDM) systems is presented when employing low-resolution data converters and per-antenna level constraints.…
Orthogonal Frequency Division Multiplexing (OFDM) combined with Multiple-Input Multiple-Output (MIMO) techniques forms the backbone of modern wireless communication systems. While offering high spectral efficiency and robustness,…
This paper analyzes the spectral efficiency of massive multiple-input multiple-output (MIMO) systems in both centralized and distributed configurations, referred to as C-MIMO and D-MIMO, respectively. By accounting for real environmental…
Target detection is an important problem in multiple-input multiple-output (MIMO) radar. Many existing target detection algorithms were proposed without taking into consideration the quantization error caused by analog-to-digital converters…
Broad beam beamforming (BF) design in multiple-input multiple-output (MIMO) can be convenient for initial access, synchronization, and sensing capabilities in cellular networks by avoiding overheads of sweeping methods while making…
Channel state information (CSI) feedback is necessary for the frequency division duplexing (FDD) multiple input multiple output (MIMO) systems due to the channel non-reciprocity. With the help of deep learning, many works have succeeded in…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
Advances in analog-to-digital converter (ADC) technology have opened up the possibility to directly digitize wideband radio frequency (RF) signals, avoiding the need for analog down-conversion. In this work, we consider an orthogonal…
In high-dynamic range (HDR) analog-to-digital converters (ADCs), having many quantization bits minimizes quantization errors but results in high bit rates, limiting their application scope. A strategy combining modulo-folding with a low-DR…
The use of one-bit analog-to-digital converter (ADC) has been considered as a viable alternative to high resolution counterparts in realizing and commercializing massive multiple-input multiple-output (MIMO) systems. However, the issue of…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
The use of low resolution Analog to Digital Converters (ADCs) can significantly reduce the power consumption for massive Multiple Input Multiple Output (MIMO) systems. The existing literature on quantized massive MIMO systems deals with…
Massive multiple-input multiple-output (MIMO) has enabled substantial spatial multiplexing and array gains in real-world systems, while distributed MIMO (D-MIMO) improves macro-diversity over wide areas at the cost of deployment complexity.…
Asynchronous distributed hybrid beamformers (ADBF) are conceived for minimizing the total transmit power subject to signal-to-interference-plus-noise ratio (SINR) constraints at the users. Our design requires only limited information…
The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…
The use of one-bit analog-to-digital converters (ADCs) at a receiver is a power-efficient solution for future wireless systems operating with a large signal bandwidth and/or a massive number of receive radio frequency chains. This solution,…