Related papers: Joint Delay-Phase Precoding Under True-Time Delay …
Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…
The application of hybrid precoding in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems has been proved effective for reducing the number of radio frequency (RF) chains. However, the maximum number of independent data…
Orthogonal frequency-division multiplexing (OFDM) time-domain signals exhibit high peak-to-average (power) ratio (PAR), which requires linear radio-frequency chains to avoid an increase in error-vector magnitude (EVM) and out-of-band (OOB)…
The multipath radio channel is considered to have a non-bandlimited channel impulse response. Therefore, it is challenging to achieve high resolution time-delay (TD) estimation of multipath components (MPCs) from bandlimited observations of…
In this paper, the problem of designing a forward link linear precoder for Massive Multiple-Input Multiple-Output (MIMO) systems in conjunction with Quadrature Amplitude Modulation (QAM) is addressed. First, we employ a novel and efficient…
Time Divison Duplex (TDD) wireless communication systems are inherently bidirectional, which facilitates exploiting channel reciprocity for pilot based channel estimation of both uplink and downlink. However, there exists a gross asymmetry…
In this paper, we consider a time-switching (TS) co-located simultaneous wireless information and power transfer (SWIPT) system consisting of multiple multi-antenna access points which serve multiple single antenna users. In this scenario,…
Block diagonalization (BD) based precoding techniques are well-known linear transmit strategies for multiuser MIMO (MU-MIMO) systems. By employing BD-type precoding algorithms at the transmit side, the MU-MIMO broadcast channel is…
Precoding for multiple-input, multiple-output (MIMO) antenna systems is considered with perfect channel knowledge available at both the transmitter and the receiver. For 2 transmit antennas and QAM constellations, an approximately optimal…
Millimeter-wave (mmWave) communication operated in frequency bands between 30 and 300 GHz has attracted extensive attention due to the potential ability of offering orders of magnitude greater bandwidths combined with further gains via…
This paper considers the implementation of Tomlinson-Harashima (TH) precoding for multiuser MIMO systems based on quantized channel state information (CSI) at the transmitter side. Compared with the results in [1], our scheme applies to…
Hybrid precoding design can be challenging for broadband millimeter-wave (mmWave) massive MIMO due to the frequency-flat analog precoder in radio frequency (RF). Prior broadband hybrid precoding work usually focuses on fully-connected array…
Time-division duplex (TDD) based massive MIMO systems rely on the reciprocity of the wireless propagation channels when calculating the downlink precoders based on uplink pilots. However, the effective uplink and downlink channels…
Millimeter-wave and terahertz technologies have been attracting attention from the wireless research community since they can offer large underutilized bandwidths which can enable the support of ultra-high-speed connections in future…
Terahertz (THz) communication is considered to be a promising technology for future 6G network. To overcome the severe attenuation and relieve the high power consumption, massive MIMO with hybrid precoding has been widely considered for THz…
This paper considers a multigateway multibeam satellite system with multiple feeds per beam. In these systems, each gateway serves a set of beams (cluster) so that the overall data traffic is generated at different geographical areas. Full…
For the practical implementation of massive multiple-input multiple-output (MIMO) systems, the hybrid processing (precoding/combining) structure is promising to reduce the high cost rendered by large number of RF chains of the traditional…
The stochastic nature of time delays and sampling intervals in Networked Control Systems poses significant challenges for controller synthesis and analysis, often leading to conservative designs and degraded performance. This work presents…
Multicast beamforming is known to improve spectral efficiency. However, its benefits and challenges for hybrid precoders design in millimeter-wave (mmWave) systems remain understudied. To this end, this paper investigates the first joint…
Benefiting from the growth of the bandwidth, Terahertz (THz) communication can support the new application with explosive requirements of the ultra-high-speed rates for future 6G wireless systems. In order to compensate for the path loss of…