Related papers: Shock impingement on a transitional hypersonic hig…
Direct numerical simulations are carried out to investigate the effect of the wall temperature on the behavior of oblique shock-wave/turbulent boundary layer interactions at freestream Mach number $2.28$ and shock angle of the wedge…
The interaction between an incident shock wave and a Mach-6 undisturbed hypersonic laminar boundary layer over a cold wall is addressed using direct numerical simulations (DNS) and wall-modeled large-eddy simulations (WMLES) at different…
We perform direct numerical simulations of shock-wave/boundary-layer interactions (SBLI) at Mach number M = 1.7 to investigate the influence of the state of the incoming boundary layer on the interaction properties. We reproduce and extend…
The present numerical investigation uses well-resolved large-eddy simulations to study the low-frequency unsteady motions observed in shock-wave/turbulent-boundary-layer interactions. Details about the numerical aspects of the simulations…
Direct numerical simulation of the Navier-Stokes equations is carried out to investigate the interaction of a conical shock wave with a turbulent boundary layer developing over a flat plate at free-stream Mach number $M_\infty = 2.05$ and…
High-speed vehicles experience a highly challenging environment in which the free-stream Mach number and surface temperature greatly influence aerodynamic drag and heat transfer. The interplay of these two parameters strongly affects the…
The mechanisms governing the low-frequency unsteadiness in the shock wave/turbulent boundary layer interaction at Mach 2 are considered. The investigation is conducted based on the numerical database issued from large-eddy simulations…
The work addresses 2D and 3D turbulent transonic flows past a wall with an expansion corner. A curved shock wave is formed upstream of a cylinder located above the corner. Numerical solutions of the Reynolds-averaged Navier-Stokes equations…
The influence of surface roughness on transition to turbulence in a Mach 4.5 boundary layer is studied using direct numerical simulations. Transition is initiated by the nonlinearly most dangerous inflow disturbance, which causes the…
A high-fidelity simulation of the shock/transitional boundary layer interaction caused by a 15-degrees axisymmetrical compression ramp is performed at a freestream Mach number of 5 and a transitional Reynolds number. The inlet of the…
This experimental and numerical study examines transition to turbulence for a Cone-Cylinder-Flare geometry at Mach 7 and across a broad Reynolds number range. The focus is set on both attached boundary layers and separated shock-boundary…
Boundary layers of adiabatic and isothermal curved walls are investigated for a supersonic turbine cascade, including the effects of shock-boundary layer interactions (SBLIs). Wall-resolved large eddy simulations (LES) are performed for a…
In this work, the stability and transition to turbulence over a blunt flat plate with different leading-edge radii are investigated computationally. The freestream Mach number is 5, the unit Reynolds number is $6\times10^7$ m$^{-1}$, and…
The effects of entropic-instabilities on the laminar-turbulent transition dynamics of a blunted flat plate at Mach~$4$ are numerically investigated through linear and nonlinear approaches. Linear wavepacket analysis reveals amplifying…
The influence of high-enthalpy effects on hypersonic turbulent boundary layers is investigated by means of direct numerical simulations (DNS). A quasi-adiabatic flat-plate air flow at free-stream Mach number equal to 10 is simulated up to…
The generation mechanism of wall heat flux is one of the fundamental problems in supersonic/hypersonic turbulent boundary layers. A novel heat decomposition formula under the curvilinear coordinate was proposed in this paper. The new…
The objective of this work is to investigate the unexplored laminar-to-turbulent transition of a heated flat-plate boundary layer with a fluid at supercritical pressure. Two temperature ranges are considered: a subcritical case, where the…
Wall cooling has substantial effects on the development of instabilities and transition processes in hypersonic boundary layers (HBLs). A sequence of linear stability theory, two-dimensional and non-linear three-dimensional DNSs is used to…
The impinging shock of varying strengths on the free shear layer in a confined supersonic cavity flow is studied numerically using the detached-eddy simulation. The resulting spatiotemporal variations are analyzed between the different…
The energy gradient method is used to analyze the turbulent generation in the transition boundary layer flow. It is found that the maximum of the energy gradient function occurs at the wall for the Blasius boundary layer flow. At this…