Related papers: Low temperature spectrum of a fiber loop laser
We report on the characterization of a commercial-core fiber-based frequency comb equipped with an intracavity electro-optic modulator (EOM). We investigate the relationship between the noise of the pump diode and the laser relative…
We describe a simple and compact architecture for generating all optical frequencies required for the laser cooling, state preparation and detection of atoms in an ultracold rubidium-87 experiment from a single 780 nm laser source. In…
High speed optical telecommunication is enabled by wavelength division multiplexing, whereby hundreds of individually stabilized lasers encode the information within a single mode optical fiber. In the seek for larger bandwidth the optical…
An analytically expression for the temperature dependence of the signal gain of an erbium-doped fiber amplifier (EDFA) pumped at 1480 \textit{nm} are theoretically obtained by solving the propagation equations with the amplified spontaneous…
Erbium (Er) ions are the gain medium of choice for fiber-based amplifiers and lasers, offering a long excited-state lifetime, slow gain relaxation, low amplification nonlinearity and noise, and temperature stability compared to…
We describe and characterize a 25 GHz laser frequency comb based on a cavity-filtered erbium fiber mode-locked laser. The comb provides a uniform array of optical frequencies spanning 1450 nm to 1700 nm, and is stabilized by use of a global…
Beginning with a continuous wave laser at 1064 nm, we generate a 30 GHz electro-optic frequency comb which contains 100 lines spanning 3 THz. The initial comb is subsequently amplified, spectrally broadened in normal dispersion photonic…
Erbium-Doped Fiber Amplifiers can present holes in spectral gain in Wavelength Division Multiplexing operation. The origin of this inhomogeneous saturation behavior is still a subject of controversy. In this paper we present both an…
The enhancement of Er$^{3+}$-based up-conversion for photovoltaics in multilayer porous silicon photonic structures is considered theoretically and experimentally. Transfer matrix simulations are used to assess the increased photonic…
Electro-optical modulation of a continuous wave laser is a highly stable way to generate frequency combs, gaining popularity in telecommunication and spectroscopic applications. These combs are generated by modulating non-linear…
A standard multimode optical fiber can be used as a general purpose spectrometer after calibrating the wavelength dependent speckle patterns produced by interference between the guided modes of the fiber. A transmission matrix was used to…
A relationship between the maximum operating temperature of semiconductor lasers and their emission wavelength is conjectured. The conjecture is supported by a wide variety of existing experimental data for visible and infrared double…
Electronic spectra of porous Si have been investigated in the region $<$4 eV below the Fermi level with specimens subjected to in situ oxygenation and thermal treatments. The significance of DOS to the photoluminescence and its degradation…
We describe a successful effort to produce a laser comb around 1.55 $\mu$m in the astronomical H band using a method based on a line-referenced, electro-optical-modulation frequency comb. We discuss the experimental setup, laboratory…
Optical spectra of highly excited quantum wires at low temperatures have been studied within the dynamically screening approximation. We found a strong Fermi-edge singularity (FES) in the photoluminescence spectra. The spectral shape and…
Strong light-matter interactions in silicon metasurfaces give rise to photothermal nonlinearities. While the effect of this strong coupling on light has been extensively studied, its impact on matter remains largely unexplored. Here, we…
Design of a mid-wave IR (MWIR) broad-band fiber-based light source exploiting four-wave mixing (FWM) in a meter long suitably designed highly nonlinear (NL) chalcogenide microstructured optical fiber (MOF) is reported. This superior FWM…
Modelocked frequency comb lasers have always operated with a single pulse circulating in the laser cavity. This meant that each laser technology had an associated limit on pulse repetition rate. Achieving higher rates required different…
We demonstrate a narrow line, fiber loop laser using Erbium-doped fiber as the gain material, stabilized by using a microsphere as a transmissive frequency selective element. Stable lasing with a linewidth of 170 kHz is observed, limited by…
We present a 2-\mum frequency comb based on a reliable mode-locked Er:fiber laser with 100 MHz repetition rate. After shifting the spectrum of the amplified Er:fiber comb to longer wavelengths, a single-clad Tm/Ho:fiber is used as a…