Related papers: Joint Waveform and Passive Beamformer Design in Mu…
Intelligent reflecting surface (IRS) has been deemed as a transformative technology to achieve smart and reconfigurable environment for wireless communication. This letter studies a new IRS-aided communication system, where multiple IRSs…
Dual-functional radar-communication (DFRC) has attracted considerable attention. This paper considers the frequency-selective multipath fading environment and proposes DFRC waveform design schemes based on multiple-input and multiple-output…
This paper investigates jointly optimal array geometry and waveform designs for active sensing. Specifically, we focus on minimizing the Cram\'er-Rao lower bound (CRB) of the angle of a single target in white Gaussian noise. We first find…
Millimeter-wave (mmWave) communications provide access to spectra with bandwidths and in abundance. However, the high susceptibility of mmWave to blockage imposes crucial challenges, especially to low-latency services. In this paper, a…
Intelligent Reflecting Surface (IRS) technology is revolutionizing wireless communications by shifting from channel adaptation to a responsive wireless environment. This paper introduces a multi-IRS assisted millimeter wave (mm-wave)…
In this paper, colocated MIMO radar waveform design is considered by minimizing the integrated side-lobe level to obtain beam patterns with lower side-lobe levels than competing methods. First, a quadratic programming problem is formulated…
In this paper, we investigate an intelligent reflecting surface (IRS) assisted multi-user multiple-input multiple-output (MIMO) full-duplex (FD) system. We jointly optimize the active beamforming matrices at the access point (AP) and uplink…
Intelligent reflecting surface (IRS) is a promising technology for achieving high spectrum efficiency in future wireless networks by leveraging massive low-cost reflecting elements with each reflecting the incident signal with a proper…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…
In this paper, we study the waveform and passive beamforming design for intelligent reflecting surface (IRS)-aided wireless power transfer (WPT). Generalized multi-user and low complexity single-user algorithms are derived based on…
In this paper, we develop a unified dynamic intelligent reflecting surface (IRS) beamforming framework to boost the sum computation rate of an IRS-aided mobile edge computing (MEC) system, where each device follows a binary offloading…
Due to its ability of significantly improving data rate, intelligent reflecting surface (IRS) will be a potential crucial technique for the future generation wireless networks like 6G. In this paper, we will focus on the analysis of degree…
The use of Intelligent Reflective Surfaces (IRS) to assist communication and sensing has proven cost-effective in challenging scenarios. For sensing, IRS is shown to sense non-line-of-sight (NLOS) and stealth targets, albeit with…
Intelligent reflecting surface (IRS), which consists of a large number of tunable reflective elements, is capable of enhancing the wireless propagation environment in a cellular network by intelligently reflecting the electromagnetic waves…
This paper investigates a downlink multiple-input single-output intelligent reflecting surface (IRS) aided non-orthogonal multiple access (NOMA) system, where a base station (BS) serves multiple users with the aid of IRSs. Our goal is to…
The mutual interference between similar radar systems can result in reduced radar sensitivity and increased false alarm rates. To address the synchronous and asynchronous interference mitigation problems in similar radar systems, we first…
A joint robust transmit/receive adaptive beamforming for multiple-input multipleoutput (MIMO) radar based on probability-constrained optimization approach is developed in the case of Gaussian and arbitrary distributed mismatch present in…
Beamforming techniques are proposed for a joint multi-input-multi-output (MIMO) radar-communication (RadCom) system, where a single device acts both as a radar and a communication base station (BS) by simultaneously communicating with…
Reconfigurable intelligent surface (RIS) is a promising technology for 6G networks owing to its superior ability to enhance the capacity and coverage of wireless communications by smartly creating a favorable propagation environment. In…
In this paper, we focus on constant-modulus waveform design for the dual use of radar target detection and cellular transmission. As the MIMO radar typically transmits orthogonal waveforms to search potential targets, we aim at jointly…