Related papers: Nanowire bolometer using a 2D high-temperature sup…
We have measured the transport properties of a series of underdoped YBa2Cu3O7 nanowires fabricated with widths of 100-250 nm. We observe large telegraph-like fluctuations in the resistance between the pseudogap temperature T* and the…
An improved nanopatterning procedure has been developed to obtain YBCO nanowires with cross sections as small as 50x50 nm^2, protected by an Au capping layer. To probe the effective role of the Au protecting layer, we have measured the…
Here we propose a new design paradigm for a superconducting nanowire single photon detector that uses a multi-layer architecture that places the electric leads beneath the nanowires. This allows for a very large number of detector elements,…
We demonstrate that a high kinetic inductance disordered superconductor can realize a low microwave loss, non-dissipative circuit element with an impedance greater than the quantum resistance ($R_Q = h/4e^2 \simeq 6.5k\Omega$). This…
The transport properties of superconducting single crystal Pb nanowires of 55 nm and 70 nm diameter are studied by standard four electrodes method. Resistance-temperature (R-T) scans and magneto-resistance (R-H) measurements show a series…
Engineering nanoscale light matter interaction in mixed dimensional semiconductor heterostructures offers a pathway to mitigate the intrinsic gain bandwidth trade off in photodetectors. Here, we report a broadband, high responsivity 2D and…
We present a design and a top-down fabrication method for realizing diamond nanowires in both bulk single crystal and polycrystalline diamond. Numerical modeling was used to study coupling between a Nitrogen Vacancy (NV) color center and…
We performed comparative experimental investigation of superconducting NbN nanowires which were prepared by means of positive-and negative electron-beam lithography with the same positive tone Poly-methyl-methacrylate (PMMA) resist. We show…
We study the low-temperature electron mobility of InSb nanowires. We extract the mobility at 4.2 Kelvin by means of field effect transport measurements using a model consisting of a nanowire-transistor with contact resistances. This model…
Electrical transport measurements were made on single-crystal Sn nanowires to understand the intrinsic dissipation mechanisms of a one-dimensional superconductor. While the resistance of wires of diameter larger than 70 nm drops…
An unusual enhancement of resistance (i.e., superresistivity) below a certain characteristic temperature Tsr was observed in granular Bi nanowires. This superresistive state was found to be dependent on the applied magnetic field (H) as…
We study nanoelectromechanical resonators fabricated from suspended flakes of NbSe$_2$ (thickness$\sim$30-50 nm) to probe charge density wave (CDW) physics at nanoscale. Variation of elastic and electronic properties accompanying the CDW…
Cryogenic calorimeters, also known as bolometers, are among the leading technologies for searching for rare events. The CUPID experiment is exploiting this technology to deploy a tonne-scale detector to search for neutrinoless double-beta…
Due to the unique three-dimensional (3-D) geometries of nanowire-i.e., large surface-to-volume ratios and smaller cross-sections at the nanowire-substrate interfaces-their carrier dynamics are much more complicated than those of thin films.…
The rising complexity of cutting-edge cryogenic systems is currently imposing challenging technical constraints to the monitoring of ultra-cold temperatures through standard commercially available sensors. Among different alternative…
Superconducting Nanowire Single Photon Detector (SNSPD) emerges as a potential candidate in the multiple fields requiring sensitive and fast photodetection. While nanowires of low temperature superconducting detectors are mature with…
The discovery of van der Waals superconductors in recent years has generated a lot of excitement for their potentially novel pairing mechanisms. However, their typical atomic-scale thickness and micrometer-scale lateral dimensions impose…
We report on efforts to improve the speed of low-G far-infrared transition-edged-sensed bolometers. We use a fabrication process that does not require any dry etch steps to reduce heat capacity on the suspended device and measure a…
We report the superconducting properties of tantalum nitride (TaN) nanowires and TaN/copper (TaN/Cu) bilayer nanowires fabricated on 300 mm silicon wafers using CMOS-compatible processes. We evaluate how an integrated Cu heatsink modifies…
Motivated by the recent observations of possible p-wave superconductivity in the bismuth-nickel (Bi/Ni) bilayer, we explore theoretically the possibilities of realizing p-wave superconductivity in this bilayer. We begin with a literature…