Related papers: Unstable growth of bubbles from a constriction
When an open tube of small diameter touches a bubble of a larger diameter, the bubble spontaneously shrinks and pushes a soap film in the tube. We characterize the dynamics for different bubble sizes and number of soap films in the tube. We…
In this paper, we study the formation process of a soap bubble by blowing soap film. Both bubble diameter and formation position were investigated in experiments. We found that the ratio between bubble size and soap film column is constant,…
Soap bubbles can be easily generated by varies methods, while their formation process is complicated and still worth study. A model about the bubble formation process was proposed in Phys. Rev. Lett. 116, 077801 recently, and it was…
We combine experiments and theoretical derivations to study the evolution of a stretched soap bubble and compare it with an open film to highlight the effect of volume conservation. We identify a critical length for both surfaces, beyond…
Bubbles have always captivated our curiosity with their aesthetics and complexities alike. While the act of blowing bubbles is familiar to everyone, the underlying physics of these fleeting spheres often eludes reasoning. In this letter, we…
We have designed and constructed an experimental system to study gas bubble growth in slightly supersatu- rated liquids. This is achieved by working with carbon dioxide dissolved in water, pressurized at a maximum of 1 MPa and applying a…
Using mixtures of soap, water, and long chain polymers, free-floating soap bubbles can be formed with volumes approaching 100 m$^3$. Here we investigate how such thin films are created and maintained over time. We show how the extensional…
We measure the liquid content, the bubble speeds, and the distribution of bubble sizes, in a vertical column of aqueous foam maintained in steady-state by continuous bubbling of gas into a surfactant solution. Nearly round bubbles…
We simulate the quasi-static motion of a spherical particle through a stable, horizontal soap film. The soap film subtends a fixed contact angle, in the range $10-135^\circ$, where it meets the particle. The tension and pressure forces…
Gas bubble growth as a result of diffusion flux of dissolved gas molecules from the surrounding supersaturated solution to the bubble surface is studied. The condition of the flux steadiness is revealed. A limitation from below on the…
The process of bubble formation from an orifice submerged in liquid with constant gas flow is studied by numerical simulations using an OpenFOAM volume-of-fluid solver named interIsoFoam. The computed results show that the detached bubble…
When a bubble of air rises to the top of a highly viscous liquid, it forms a dome-shaped protuberance on the free surface. Unlike a soap bubble, it bursts so slowly as to collapse under its own weight simultaneously, and folds into a…
Soap bubbles are by essence fragile and ephemeral. Depending on their composition and environment, bubble bursting can be triggered by gravity-induced drainage and/or the evaporation of the liquid and/or the presence of nuclei. They can…
In this paper, the size of bubbles formed through the breakup of a gaseous jet in a co-axial microfluidic device is derived. The gaseous jet surrounded by a co-flowing liquid stream breaks up into monodisperse microbubbles and the size of…
Surface bubbles have attracted much interest in the past decades. In this article, we propose to explore the lifetime and thinning dynamics of centimetric surface bubbles. We study the impact of the bubbles size as well as that of the…
The spherical dynamics of a bubble in a compressible liquid has been studied extensively since the early work of Gilmore. Numerical codes to study the behavior, including when large non-spherical deformations are involved, have since been…
We investigate continuous generation of bubbles from a bath of air in viscous liquid in a confined geometry. In our original setup, bubbles are spontaneously generated by virtue of buoyancy and a gate placed in the cell: the gate acts like…
Soap bubbles are thin liquid films enclosing a fixed volume of air. Since the surface tension is typically assumed to be the only responsible for conforming the soap bubble shape, the realized bubble surfaces are always minimal area ones.…
The formation of a single bubble from an orifice in a solid surface, submerged in an in- compressible, viscous Newtonian liquid, is simulated. The finite element method is used to capture the multiscale physics associated with the problem…
Cavitation in tubes is a common occurrence in nature and engineering applications. Previous studies of cavitation bubble dynamics mainly consider bubbles in stagnant-water tubes, but the dynamics of cavitation bubbles in tubes with flow is…