Related papers: Receiver Bandwidth Extension Beyond Nyquist Using …
To accommodate new applications such as extended reality, fully autonomous vehicular networks and the metaverse, next generation wireless networks are going to be subject to much more stringent performance requirements than the…
We optimize theoretically and experimentally the performances of the recently demonstrated modulation transfer protocol [D.-A. Trinh, K. V. Adwaith, M. Branco, A. Rouxel, S. Welinski, P. Berger, F. Goldfarb, and F. Bretenaker, Applied…
Detecting microwave signals over a wide frequency range has numerous advantages as it enables simultaneous transmission of a large amount of information and access to more spectrum resources. This capability is crucial for applications such…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
Optical communication systems, which operate at very high rates, are often limited by the sampling rate bottleneck. The optical wideband regime may exceed analog to digital converters (ADCs) front-end bandwidth. Multi-channel sampling…
The scaling of coherent and non-coherent channel capacity is studied in a single-input multiple-output (SIMO) block Rayleigh fading channel as both the bandwidth and the number of receiver antennas go to infinity jointly with the transmit…
Oversampling combined with low quantization resolutions has been shown to be a viable option when aiming for energy efficiency in multigigabit/s communications systems. This work considers the case of 1-bit quantization combined with…
Integrated sensing and communication (ISAC) has been envisioned as a solution to realize the sensing capability required for emerging applications in wireless networks, while efficiently utilizing the available spectral, hardware and energy…
With bandwidths on the order of a gigahertz in emerging wireless systems, high-resolution analog-to-digital convertors (ADCs) become a power consumption bottleneck. One solution is to employ low resolution one-bit ADCs. In this paper, we…
The maximum information rates for bandlimited channels with direct detection are achieved with joint detection and decoding (JDD), but JDD is often too complex to implement. Two receiver structures are studied to reduce complexity: separate…
In this article, we use deep neural networks (DNNs) to develop a wireless end-to-end communication system, in which DNNs are employed for all signal-related functionalities, such as encoding, decoding, modulation, and equalization. However,…
This article revisits integrated sensing and communication (ISAC) systems that operate in the near-field region of large antenna arrays while utilizing large bandwidths. The article first describes the basic characteristics of a wideband…
Cognitive radio has emerged as one of the most promising candidate solutions to improve spectrum utilization in next generation cellular networks. A crucial requirement for future cognitive radio networks is wideband spectrum sensing:…
We investigate the response bandwidth of a superheterodyne Rydberg receiver at a room-temperature vapor cell, and present an architecture of multi-channel lasers excitation to increase the response bandwidth and keep sensitivity,…
Nowadays, millimeter-wave communication centered at the 60 GHz radio frequency band is increasingly the preferred technology for near-field communication since it provides transmission bandwidth that is several GHz wide. The IEEE 802.11ad…
High-bandwidth signals are needed in many applications like radar, sensing, measurement and communications. Especially in optical networks, the sampling rate and analog bandwidth of digital-to-analog converters (DACs) is a bottleneck for…
We consider communication over a multiple-input single-output (MISO) block fading channel in the presence of an independent noiseless feedback link. We assume that the transmitter and receiver have no prior knowledge of the channel state…
Many communication systems involve high bandwidth, while sparse, radio frequency (RF) signals. Working with high frequency signals requires appropriate system-level components such as high-speed analog-to-digital converters (ADC). In…
Providing broadband connectivity to airborne systems using ground based cellular networks is a promising solution as it offers several advantages over satellite-based solutions. However, limited range of terrestrial base stations is a key…
Next-generation cellular technologies, commonly referred to as the 6G, are envisioned to support a higher system capacity, better performance, and network sensing capabilities. The THz band is one potential enabler to this end due to the…