Related papers: Performance Evaluation of Wireless Multi-Carrier (…
In spatially distributed multiuser antenna systems, the received signal contains multiple carrier-frequency offsets (CFOs) arising from mismatch between the oscillators of transmitters and receivers. This results in a time-varying rotation…
Future space observatories achieve detection of gravitational waves by interferometric measurements of a carrier phase, allowing to determine relative distance changes, in combination with an absolute distance measurement based on the…
With the emergence of new applications (e.g., extended reality and haptics), which require to be simultaneously served not just with low latency and sufficient reliability, but also with high spectral efficiency, future networks (i.e., 6G)…
In this paper, we investigate the performance gains of adapting pilot spacing and power for Carrier Aggregation (CA)-OFDM systems in nonstationary wireless channels. In current multi-band CA-OFDM wireless networks, all component carriers…
In the existing literature on joint timing and frequency synchronization of orthogonal time frequency space modulation (OTFS), practically infeasible impulse pilot with large peak-to-average power ratio (PAPR) is deployed. Hence, in this…
Low-complexity estimation and correction of carrier frequency offset (CFO) are essential in orthogonal frequency division multiplexing (OFDM). In this paper, we propose a low-overhead blind CFO estimation technique based on cyclic prefix…
Cooperative integrated sensing and communication (ISAC) based on orthogonal frequency-division multiplexing (OFDM) enables network-wide sensing by exploiting the spatial diversity of multi-base-station (BS). This paper studies performance…
Ambient backscatter communication (AmBC) over orthogonal-frequency-division-multiplexing (OFDM) signals has recently been proposed as an appealing technique for low power Internet-of-Things (IoT) applications. The special spectrum structure…
In this paper, we investigate a distributed multi-input multi-output and orthogonal frequency division multiplexing (MIMO-OFDM) dual-function radar-communication (DFRC) system, which enables simultaneous communication and sensing in…
In this paper, we present bandwidth efficient retransmission method employong selective retransmission approach at modulation layer under orthogonal frequency division multiplexing (OFDM) signaling. Our proposed cross-layer design embeds a…
In this paper, we propose an efficient beam tracking method for mobility scenario in mmWave-band communications. When the position of the mobile changes in mobility scenario, the base-station needs to perform beam training frequently to…
Due to the implementation bottleneck of training data collection in realistic wireless communications systems, supervised learning-based timing synchronization (TS) is challenged by the incompleteness of training data. To tackle this…
Multiple transmitting antennas can considerably increase the downlink spectral efficiency by beamforming to multiple users at the same time. However, multiuser beamforming requires channel state information (CSI) at the transmitter, which…
Wireless relaying is one of the promising solutions to overcome the channel impairments and provide high data rate coverage that appears for beyond 3G mobile communications. In this paper we present an end to end BER performance analysis of…
Cell-free (CF) massive multiple-input multiple-output (MIMO) is considered as a promising technology for achieving the ultimate performance limit. However, due to its distributed architecture and low-cost access points (APs), the signals…
The optimization of the pilot overhead in single-user wireless fading channels is investigated, and the dependence of this overhead on various system parameters of interest (e.g., fading rate, signal-to-noise ratio) is quantified. The…
Orthogonal frequency-division multiplexing (OFDM) is a dominant waveform in modern wireless systems, yet its high peak-to-average power ratio (PAPR) and limited adaptability hinder efficient support for integrated communication and sensing.…
5G systems aim to achieve extremely high data rates, low end-to-end latency and ultra-low power consumption. Recently, there has been considerable interest in the design of 5G physical layer waveforms. One important candidate is Generalised…
Broad beam beamforming (BF) design in multiple-input multiple-output (MIMO) can be convenient for initial access, synchronization, and sensing capabilities in cellular networks by avoiding overheads of sweeping methods while making…
The increasing demand on the internet trafficking to meet the demands of video streaming and mobile communication has exerted too much pressure. Accordingly, this demand will result in providing high bandwidth which in turn increase the use…