Related papers: Simulation of Medium-Frequency R-Mode Signal Stren…
Increasing levels of Radio Frequency Interference (RFI) are a problem for research in radio astronomy. Various techniques to suppress RFI and extract astronomical signals from data affected by interference are being tried out. However,…
A multimode microcavity sensor based on a self-interference microring resonator is demonstrated experimentally. The proposed multimode sensing method is implemented by recording wideband transmission spectra that consist of multiple…
With the rapid increase in mobile subscribers, there is a drive towards achieving higher data rates, prompting the use of higher frequencies in future wireless communication technologies. Wave propagation channel modeling for these…
In this paper, we consider the downlink of a massive multiple-input-multiple-output (MIMO) single user transmission system operating in the millimeter wave outdoor narrowband channel environment. We propose a novel receive spatial…
The Global Positioning System (GPS) has become the most widely used positioning, navigation, and timing system. However, the vulnerability of GPS to radio frequency interference has attracted significant attention. After experiencing…
Received signal strength based respiration rate monitoring is emerging as an alternative non-contact technology. These systems make use of the radio measurements of short-range commodity wireless devices, which vary due to the inhalation…
Rydberg electric field sensors exploit the large number of Rydberg resonances to provide sensitivity over a broad range of the electromagnetic spectrum. However, due to the difficulty of accessing resonant Rydberg states at ultra-high…
Millimeter wave signals with multiple transmit and receive antennas are considered as enabling technology for enhanced mobile broadband services in 5G systems. While this combination is mainly associated with achieving high data rates, it…
Nowadays, micromagnetic simulations are a common tool for studying a wide range of different magnetic phenomena, including the ferromagnetic resonance. A technique for evaluating reliability and validity of different micromagnetic…
Joint radar-communication (JRC) waveform can be used for simultaneous radar detection and communication in the same frequency band. However, radar detection processing requires the prior knowledge of the waveform including the embedded…
The vulnerabilities of global navigation satellite systems (GNSSs) to radio frequency jamming and spoofing have attracted significant research attention. In particular, the large-scale jamming incidents that occurred in South Korea…
Stabilizing the gain of a radio astronomy receiver is of great importance for sensitive radio intensity mapping. In this paper we discuss a stabilization method using a continuous-wave reference signal injected into the signal chain and…
Minimizing the symbol error in the uplink of multi-user multiple input multiple output systems is important, because the symbol error affects the achieved signal-to-interference-plus-noise ratio (SINR) and thereby the spectral efficiency of…
To support the high data rates for latency-critical applications, future wireless systems will employ fully digital beamforming multiple-input multiple-output (MIMO) architectures at millimeter wave (mmWave) frequencies. Moreover, mmWave…
In this paper, the field measurements of signal strength taken at the frequency of 2432 MHz in indoor & outdoor environments are presented and analyzed. The received signal levels from the base station were monitored manually. Total…
In this paper, estimation of mobility using received signal strength is presented. In contrast to standard methods, speed can be inferred without the use of any additional hardware like accelerometer, gyroscope or position estimator. The…
This paper studies the detection performance of a multiple-input-multiple-output (MIMO) multifunction radio frequency (MFRF) system, which simultaneously supports radar, communication, and jamming. We show that the detection performance of…
The susceptibility of millimeter-wave (mmWave) signals to physical blockage and abrupt signal strength variations presents a challenge to reliable 5G communication. This work proposes and examines the feasibility of utilizing…
Using multimodal sensory data can enhance communications systems by reducing the overhead and latency in beam training. However, processing such data incurs high computational complexity, and continuous sensing results in significant power…
This two-part paper focuses on the system design and performance analysis for a point-to-point resonant beam communication (RBCom) system under both the quasi-static and mobile scenarios. Part I of this paper proposes a…