Related papers: Joint Activity Detection and Channel Estimation fo…
Massive machine type communication (mMTC) is one of the three fifth generation mobile networking (5G) key usage scenarios, which is characterized by a very large number of connected devices typically transmitting a relatively low volume of…
This paper proposes a closed-loop sparse channel estimation (CE) scheme for wideband millimeter-wave hybrid full-dimensional multiple-input multiple-output and time division duplexing based systems, which exploits the channel sparsity in…
Massive device connectivity in Internet of Thing (IoT) networks with sporadic traffic poses significant communication challenges. To overcome this challenge, the serving base station is required to detect the active devices and estimate the…
Hybrid massive MIMO structures with reduced hardware complexity and power consumption have been widely studied as a potential candidate for millimeter wave (mmWave) communications. Channel estimators that require knowledge of the array…
In this article, we investigate channel estimation for wideband millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) under hybrid architecture with lowprecision analog-to-digital converters (ADCs). To design channel…
In this paper, we investigate the performance of cell-free massive MIMO systems with massive connectivity. With the generalized approximate message passing (GAMP) algorithm, we obtain the minimum mean-squared error (MMSE) estimate of the…
An intelligent reflecting surface (IRS)-assisted millimeter-wave (mmWave) massive multiple input multiple output (MIMO) system with transmit antenna selection (TAS) using orthogonal space-time block codes (OSTBC) scheme is proposed in this…
Due to the increase of Internet-of-Things (IoT) devices, IoT networks are getting overcrowded. Networks can be extended with more gateways, increasing the number of supported devices. However, as investigated in this work, massive MIMO has…
This paper proposes a correlation-based three-stage channel estimation strategy with low pilot overhead for reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) multi-user (MU) MIMO systems, in which both users and base…
Recently, non-orthogonal codes have been advocated for IoT massive access. Activity detection has been demonstrated to entail common support recovery in a jointly sparse multiple measurement vector (MMV) problem and MMV algorithms have been…
The problem of beam alignment (BA) in a cell-free massive multiple-input multiple-output (CF-mMIMO) system operating at millimeter wave (mmWaves) carrier frequencies is considered in this paper. Two estimation algorithms are proposed, in…
Massive connectivity and low latency are two important challenges for the Internet of Things (IoT) to achieve the Quality of Service (QoS) provisions required by the numerous devices it is designed to service. Motivated by these challenges,…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
In this paper, we consider a multiuser massive single-input multiple-output (SIMO) enabled Industrial Internet of Things (IIoT) communication system. To reduce the latency and overhead caused by channel estimation, we assume that only the…
Existing wireless communication systems have been mainly designed to provide substantial gain in terms of data rates. However, 5G and Beyond will depart from this scheme, with the objective not only to provide services with higher data…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems typically employ hybrid mixed signal processing to avoid expensive hardware and high training overheads. {However, the lack of fully digital beamforming at…
In future wireless networks, one fundamental challenge for massive machine-type communications (mMTC) lies in the reliable support of massive connectivity with low latency. Against this background, this paper proposes a compressive sensing…
Current IoT networks are characterized by an ultra-high density of devices with different energy budget constraints, typically having sparse and sporadic activity patterns. Access points require an efficient strategy to identify the active…
In this paper, we investigate the performance of an integrated sensing and communication (ISAC) system within a cell-free massive multiple-input multiple-output (MIMO) system. Each access point (AP) operates in the millimeter-wave (mmWave)…
In the conventional multiuser MIMO systems, user selection and scheduling has previously been used as an effective way to increase the sum rate performance of the system. However, the recent concepts of the massive MIMO systems (at…