Related papers: High-resolution time-to-digital converters (TDCs) …

The prototype of a TDC board has been developed for the new high granular time-of-flight neutron detector (HGND). The board is based on the standard LVDS 4x asynchronous oversampling using the xc7k160 FPGA with a 100 ps bin width. The HGND…

Recent works propose neural network- (NN-) inspired analog-to-digital converters (NNADCs) and demonstrate their great potentials in many emerging applications. These NNADCs often rely on resistive random-access memory (RRAM) devices to…

We present the timing characteristics of the flash ADC readout of the GlueX forward calorimeter, which depends on precise measurement of arrival time of pulses from FEU 84-3 photomultiplier tubes to suppress backgrounds. The tests presented…

Efficient telecom frequency conversion (TFC) in atomic systems is crucial for integrating atom-based quantum nodes into low-loss fiber-optic quantum networks. Here, we demonstrate high-efficiency TFC from 795 nm to 1367 nm in a cold 87Rb…

The SAMpler for PICosecond time (SAMPIC) chip has been designed by a collaboration including CEA/IRFU/SEDI, Saclay and CNRS/LAL/SERDI, Orsay. It benefits from both the quick response of a time to digital converter and the versatility of a…

This paper presents the design and analysis of a wearable CMOS biosensor with three different designs of energy-resolution scalable time-based resistance to digital converters (RDC), targeted towards either minimizing the energy/conversion…

An ultra-high-speed waveform digitizer prototype based on gigabit Ethernet has been developed. The prototype is designed to read out signals of detectors to realize the accurate measurement of various physical quantities for plasma…

A new TDC-chip is under development for the COMPASS experiment at CERN. The ASIC, which exploits the 0.6 micrometer CMOS sea-of-gate technology, will allow high resolution time measurements with digitization of 75 ps, and an unprecedented…

We present some aspects of photon counting to study scintillators at low temperatures. A time-to-digital converter (TDC) had been configured to acquire several-minute-long streams of data, simplifying the multiple photon counting…

With the new generation of the RPC, it is possible to work with induced signals of hundreds $\mu V$, hence the front-end electronics is an important and delicate part of the detector in order to get a detectable signal. The electronic chain…

Identifying light mesons which contain only up/down quarks (pions) from those containing a strange quark (kaons) over the typical meter length scales of a particle physics detector requires instrumentation capable of measuring flight times…

Radiation hard helium gas ionization chambers capable of operating in vacuum at temperatures ranging from 5K to 350K have been designed, fabricated and tested and will be used inside the cryostats at Fermilab's Superconducting…

We present TTC, an open-source parallel compiler for multidimensional tensor transpositions. In order to generate high-performance C++ code, TTC explores a number of optimizations, including software prefetching, blocking, loop-reordering,…

A Time to Digital Converter (TDC) based system, to be used for most sub-detectors in the high-flux rare-decay experiment NA62 at CERN SPS, was built as part of the NA62 fully digital Trigger and Data AcQuisition system (TDAQ), in which the…

Low resolution analog-to-digital converters (ADCs) can be employed to improve the energy efficiency (EE) of a wireless receiver since the power consumption of each ADC is exponentially related to its sampling resolution and the hardware…

In recent years, Compute-in-memory (CiM) architectures have emerged as a promising solution for deep neural network (NN) accelerators. Multiply-accumulate~(MAC) is considered a {\textit de facto} unit operation in NNs. By leveraging the…

A 3.8ps root mean square (RMS) time synchronization implemented in a 20nm fabrication process ultrascale kintex Field Programmable Gate Array (FPGA) is presented. The multichannel high-speed serial transceivers (e.g. GTH) play a key role in…

Recent approaches to develop infrared photodetectors characterized by high sensitivities, broadband spectral coverage, easy integration with silicon electronics and low cost have been based on hybrid structures of transition metal…

A highly integrated, high performance, and re-configurable device, which is designed for the Nitrogen-Vacancy center based quantum applications, is reported. The digital compartment of the device is fully implemented in a…

We demonstrate near unity, broadband absorbing optoelectronic devices using sub-15 nm thick transition metal dichalcogenides (TMDCs) of molybdenum and tungsten as van der Waals semiconductor active layers. Specifically, we report that…