Related papers: Dynamic RF Beam Codebook Reduction for Cost-Effici…
A new method for capacity and spectral efficiency increases is a full-duplex (FD) communication, where sending and receiving are done simultaneously. Hence, severe interference leaked from the transmitter to the receiver, which can disrupt…
Dynamic Metasurface Antennas (DMAs) constitute a promising solution for extremely large antenna arrays, requiring lower power consumption and reduced hardware cost as compared to conventional phased arrays. In this paper, we consider a…
Millimeter-wave communications rely on narrow-beam transmissions to cope with the strong signal attenuation at these frequencies, thus demanding precise alignment between transmitter and receiver. However, the beam-alignment procedure may…
This paper focuses on energy recycling in full-duplex (FD) relaying multiple-input-multiple-output orthogonal frequency division multiplexing (OFDM) communication. The loop self-interference (SI) due to full-duplexing is seen as an…
The recent significant progress in realizing full-duplex~(FD) systems has opened up a promising avenue for improving quality of service (QoS) and quality of experience (QoE) in future wireless networks. There is an urgent need to address…
Intelligent reflecting surfaces (IRS) have emerged as a promising technology to enhance the performance of wireless communication systems. By actively manipulating the wireless propagation environment, IRS enables efficient signal…
Theoretically, full-duplex (FD) communications can double the spectral-efficiency (SE) of a wireless link if the problem of self-interference (SI) is completely eliminated. Recent developments towards SI cancellation techniques have allowed…
In this paper, we study efficient beam coverage design for multi-antenna systems in both far-field and near-field cases. To reduce the computational complexity of existing sampling-based optimization methods, we propose a new low-complexity…
This paper investigates downlink radio resource management (RRM) in millimeter-wave systems with codebook-based hybrid beamforming in a single cell. We consider a practical but often overlooked multi-channel scenario where the base station…
To develop a low-complexity multicast beamforming method for millimeter wave communications, we first propose a channel gain estimation method in this article. We use the beam sweeping to find the best codeword and its two neighboring…
Millimeter-wave (mmWave) communications is considered as a key enabler towards the realization of next-generation wireless networks, due to the abundance of available spectrum at mmWave frequencies. However, mmWave suffers from high…
Recently, reconfigurable intelligent surface (RIS) has immensely been deployed to overcome blockage issue and widen coverage for enabling superior performance 6G networks. Mainly, systems use RIS as an assistant to redirect the transmitter…
Integrated Sensing and Communication (ISAC) has attracted substantial attraction in recent years for spectral efficiency improvement, enabling hardware and spectrum sharing for simultaneous sensing and signaling operations. In-band Full…
Millimeter wave (mmWave) massive MIMO can achieve orders of magnitude increase in spectral and energy efficiency, and it usually exploits the hybrid analog and digital precoding to overcome the serious signal attenuation induced by mmWave…
This paper addresses the modeling and digital cancellation of self-interference in in-band full-duplex (FD) transceivers with multiple transmit and receive antennas. The self-interference modeling and the proposed nonlinear spatio-temporal…
Hybrid beamforming is a promising technology to improve the energy efficiency of massive MIMO systems. In particular, subarray hybrid beamforming can further decrease power consumption by reducing the number of phase-shifters. However,…
Many areas in science and engineering now have access to technologies that enable the rapid collection of overwhelming data volumes. While these datasets are vital for understanding phenomena from physical to biological and social systems,…
Beamforming technology is widely used in millimeter wave systems to combat path losses, and beamformers are usually selected from a predefined codebook. Unfortunately, the traditional codebook design neglects the beam squint effect, and…
This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…
In this letter, we investigate the hybrid beamforming based on deep reinforcement learning (DRL) for millimeter Wave (mmWave) multi-user (MU) multiple-input-single-output (MISO) system. A multi-agent DRL method is proposed to solve the…