Related papers: A Multichannel RF Transceiver Array with mixed L-C…
Multiarm interferometers can enhance measurement precision and provide multiparameter capability to the measurement. Their realisation requires multiport beam splitters, which has been a long-standing challenge in free-space and integrated…
Magnetic resonance imaging-guided linear accelerators (MRI-Linacs) are an emerging treatment technology that enable online soft-tissue visualisation and adaptive radiotherapy. The Australian 1.0 T MRI-Linac employs a fixed, inline beamline,…
Next generation communication and sensing require enabling technologies for miniaturized and efficient heterogeneous systems while integrating technologies ranging from silicon to compound semiconductors and from photonic chips to…
Cognitive multiple-input multiple-output (MIMO) radar is capable of adjusting system parameters adaptively by sensing and learning in complex dynamic environment. Beamforming performance of MIMO radar is guided by both beamforming weight…
Dual-function radar communications (DFRC) systems have recently been proposed to enable the coexistence of radar and wireless communications, which in turn alleviates the increased spectrum congestion crisis. In this paper, we consider the…
We present a multi-chroic kinetic inductance detector (KID) pixel design integrated with a broadband hierarchical phased-array antenna. Each low-frequency pixel consists of four high-frequency pixels. Four passbands are designed from 125 to…
Dense waveguide arrays with half-wavelength-pitch, low-crosstalk, broadband, and flexible routing capability are essential for integrated photonics. However, achieving such performance is challenging due to the relatively weaker confinement…
Here we propose double-coil setup to allow high signal-to-noise ratio broad-range heteronuclear magnetic resonance imaging experiments: two independent coils, one of them tuned to $^{1}$H frequency to perform anatomical $^{1}$H imaging, and…
We present a conceptual framework of planar SIS mixer array receivers and the studies on the required techniques. This concept features membrane-based on-chip waveguide probes and a quasi-two-dimensional local-oscillator distribution…
This paper presents the design and fabrication of leaky-wave holograms with anisotropic properties, enabling circular polarization for single-beam radiation in desired directions. Tailored for future terrestrial networks like 5G, 6G, and…
Exploiting multi-antenna technologies for robust beamsteering to overcome the effects of blockage and beam misalignment is the key to providing seamless multi-Gbps connectivity in millimeter-wave (mm-wave) networks. In this paper, we…
Millimeter-wave (mmWave) systems use directional beams to support high-rate data communications. Small misalignment between the transmit and receive beams (e.g., due to the mobility) can result in significant drop of the received signal…
Due to high bandwidth and small antenna size, millimeter-wave (mmWave) integrated line-of-sight (LOS) multiple-input-multiple-output (MIMO) systems have attracted much attention. Reconfigurable intelligent surfaces (RISs), which have the…
The multilayer structure is a promising technique used to minimize the size of planar microstrip filters. In the flexible design and incorporation of other microwave components, multilayer band-pass filter results in better and enhanced…
A new method of angle estimation of multiple targets using a distributed interferometric antenna array and wideband space-time modulation is presented in this work. Interferometric array measurements of angle of arrival are generally…
Ingestible sensor devices, which are increasingly used for internal health monitoring, rely on antennas to perform sensing functions and simultaneously to communicate with external devices. Despite the development of various ingestible…
This paper describes a new Heterodyne Array Receiver Programme (HARP) and Auto-Correlation Spectral Imaging System (ACSIS) that have recently been installed and commissioned on the James Clerk Maxwell Telescope (JCMT). The 16-element…
Milimeter wave (mmWave) band mobile communications can be a solution to the continuously increasing traffic demand in modern wireless systems. Even though mmWave bands are scarcely occupied, the design of a prospect transceiver should…
We present a design for an array of kinetic inductance detectors (KIDs) integrated with phased array antennas for imaging at 150 GHz under high background conditions. The microstrip geometry KID detectors are projected to achieve photon…
The signal processing firmware that has been developed for the Low Frequency Aperture Array component of the Square Kilometre Array is described. The firmware is implemented on a dual FPGA board, that is capable of processing the streams…