Related papers: LISA Point-Ahead Angle Control for Optimal Tilt-to…
We anticipate noise from the Laser Interferometer Space Antenna (LISA) will exhibit nonstationarities throughout the duration of its mission due to factors such as antenna repointing, cyclostationarities from spacecraft motion, and glitches…
Tilt-to-length coupling is a technical term for the cross-coupling of angular or lateral jitter into an interferometric phase signal. It is an important noise source in precision interferometers and originates either from changes in the…
Tilt-to-length coupling was the limiting noise source in LISA Pathfinder between 20 and 200 mHz before subtraction in post-processing. To prevent the adding of sensing noise to the data by the subtraction process, the success of this…
This document briefly describes the noise models and shapes used for the synthesis of the Drag-Free and Attitude Control System in the LISA space mission. LISA (Laser Interferometer Space Antenna) is one of the next large-class missions…
Space-based gravitational wave detectors based on the Laser Interferometer Space Antenna (LISA) design operate by synthesizing one or more interferometers from fringe velocity measurements generated by changes in the light travel time…
Tilt-to-length (TTL) coupling is expected to be one of the major noise sources in the interferometric phase readouts in TianQin mission. Arising from the angular motion of spacecraft (SC) and the onboard movable optical subassemblies…
The orbital motion of the Laser Interferometer Space Antenna (LISA) introduces modulations into the observed gravitational wave signal. These modulations can be used to determine the location and orientation of a gravitational wave source.…
The LISA mission is a space interferometer aiming at the detection of gravitational waves in the [$10^{-4}$,$10^{-1}$] Hz frequency band. In order to reach the gravitational wave detection level, a Time Delay Interferometry (TDI) method…
Tilt-to-length (TTL) coupling, caused by the jitter of test masses or satellites, is a significant noise source in space-based gravitational wave detection. Calibrating and suppressing TTL coupling noise at the sub-nanometer level is…
Laser frequency noise suppression is a critical requirement for the Laser Interferometer Space Antenna (LISA) mission to detect gravitational waves. The baseline laser stabilization is achieved using cavity pre-stabilization and a…
Laser frequency stabilization is notably one of the major challenges on the way to a space-borne gravitational wave observatory. The proposed Laser Interferometer Space Antenna (LISA) is presently under development in an ESA, NASA…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
The Laser Interferometer Space Antenna (LISA) is a European Space Agency mission that aims to measure gravitational waves in the millihertz range. The three-spacecraft constellation forms a nearly-equilateral triangle, which experiences…
The random superposition of many weak sources will produce a stochastic background of gravitational waves that may dominate the response of the LISA (Laser Interferometer Space Antenna) gravitational wave observatory. Unless something can…
The LISA mission will likely be a signal dominated detector, such that one challenge is the separation of the different astrophysical sources, and to distinguish between them and the instrumental noise. One of the goals of LISA is to probe…
LISA is an array of three spacecraft flying in an approximately equilateral triangle configuration, which will be used as a low-frequency detector of gravitational waves. Recently a technique has been proposed for suppressing the phase…
The LISA mission is the future space-based gravitational wave (GW) observatory of the European Space Agency. It is formed by 3 spacecraft exchanging laser beams in order to form multiple real and virtual interferometers. The data streams to…
Arm locking is a technique that has been proposed for reducing laser frequency fluctuations in the Laser Interferometer Space Antenna (LISA), a gravitational-wave observatory sensitive in the milliHertz frequency band. Arm locking takes…
The ESA/NASA joint LISA (laser interferometer space antenna) mission is designed to detect gravitational waves, which relies crucially on maintaining three-spacecraft constellation as close to an equilateral triangle with a designed…
The planned Laser Interferometer Space Antenna (LISA) will detect gravitational wave signals from a wide range of sources. However, disentangling individual signals from the source-dominated data stream is a challenging problem and the…