Related papers: Fast Compressive Channel Estimation for MmWave MIM…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Hybrid beamformer design plays very crucial role in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output) systems. Previous works assume the perfect channel state information (CSI) which results heavy…
Beam alignment is key in enabling millimeter wave and terahertz radios to achieve their capacity. Due to the use of large arrays in these systems, the common exhaustive beam scanning results in a substantial training overhead. Prior work…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
This paper develops efficient channel estimation techniques for millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems under practical hardware limitations, including an arbitrary array geometry and a hybrid hardware…
Millimeter wave multiple-input multiple-output (MIMO) communication systems must operate over sparse wireless links and will require large antenna arrays to provide high throughput. To achieve sufficient array gains, these systems must…
Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…
In this paper, we consider channel estimation for intelligent reflecting surface (IRS)-assisted millimeter wave (mmWave) systems, where an IRS is deployed to assist the data transmission from the base station (BS) to a user. It is shown…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
Exploiting channel sparsity at millimeter wave (mmWave) frequencies reduces the high training overhead associated with the channel estimation stage. Compressive sensing (CS) channel estimation techniques usually adopt the (overcomplete)…
To support millimeter wave (mmWave) frequency bands in cellular communications, both the base station and the mobile platform utilize large antenna arrays to steer narrow beams towards each other to compensate the path loss and improve…
Compressed sensing (CS) schemes are proposed for monostatic as well as synthetic aperture radar (SAR) imaging with chirped signals and Ultra-Narrowband (UNB) continuous waveforms. In particular, a simple, perturbation method is developed to…
In wideband millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, channel estimation is challenging due to the hybrid analog-digital architecture, which compresses the received pilot signal and makes channel…
Using millimeter-wave (mmWave) bands is expected to provide high data rates through large licensed and unlicensed spectrum. Due to large path loss and sparse scattering propagation properties, proper beam alignment is important in mmWave…
The acquisition of channel state information (CSI) is essential in MIMO-OFDM communication systems. Data-aided enhanced receivers, by incorporating domain knowledge, effectively mitigate performance degradation caused by imperfect CSI,…
We address the problem of fast time-varying channel estimation in millimeter-wave (mmWave) MIMO systems with imperfect channel state information (CSI) and facilitate efficient channel reconstruction. Specifically, leveraging the low-rank…
In this paper, we adopt a three-stage based uplink channel estimation protocol with reduced pilot overhead for an reconfigurable intelligent surface (RIS)-aided multi-user (MU) millimeter wave (mmWave) communication system, in which both…
To develop a low-complexity multicast beamforming method for millimeter wave communications, we first propose a channel gain estimation method in this article. We use the beam sweeping to find the best codeword and its two neighboring…
In this paper, a joint design of instantaneous channel estimation, beam tracking, and adaptive beamformer construction for a massive multiple-input multiple-output (MIMO) system is proposed. This design focuses on efficiency in terms of…
Channel state information (CSI) at the base station (BS) is crucial to achieve beamforming and multiplexing gains in multiple-input multiple-output (MIMO) systems. State-of-the-art limited feedback schemes require feedback overhead that…