Related papers: Modulo Sampling of FRI Signals
This article presents a two-stage approach for the processing of frequency-stacked mobile subbands. The frequency stacking is performed in the analog domain to enable the use of a wideband analog-to-digital converter (ADC), instead of…
Phase-modulated continuous-wave (PMCW) multiple-input multiple-output (MIMO) radar systems are known to possess excellent mutual interference mitigation capabilities, but require costly and power-hungry high sampling rate and high-precision…
Modulo sampling has recently drawn a great deal of attention for cutting-edge applications, due to overcoming the barrier of information loss through sensor saturation and clipping. This is a significant problem, especially when the range…
High resolution analog to digital converters (ADCs) are conventionally used at the receiver terminals to store an accurate digital representation of the received signal, thereby allowing for reliable decoding of transmitted messages.…
This paper considers uplink massive multiple-input multiple-output (MIMO) systems with lowresolution analog-to-digital converters (ADCs) over Rician fading channels. Maximum-ratio-combining (MRC) and zero-forcing (ZF) receivers are…
The frequency-domain approach (FDA) to transient analysis of the boundary element method, although is appealing for engineering applications, is computationally expensive. This paper proposes a novel adaptive frequency sampling (AFS)…
In this contribution, it is proposes to limit the quantization search space of a successive approximation analog-to-digital converter through an analytic derivation of maximum possible sample-to-sample variation. The presented example…
Affine frequency division multiplexing (AFDM), an emerging multi-carrier modulation scheme, has garnered significant attention due to its resilience to Doppler shifts and capability to achieve full diversity in doubly dispersive channels.…
The use of low-resolution analog-to-digital converters (ADCs) is considered to be an effective technique to reduce the power consumption and hardware complexity of wireless transceivers. However, in systems with low-resolution ADCs,…
This paper presents a fully integrated second-order level-crossing sampling data converter for real-time data compression and feature extraction. Compared with level-sampling ADCs which sample at fixed voltage levels, the proposed circuits…
Analog to Digital Converters (ADCs) are a major contributor to the energy consumption on the receiver side of millimeter-wave multiple-input multiple-output (MIMO) systems with large antenna arrays. Consequently, there has been significant…
The use of low-precision analog-to-digital converters (ADCs) is a low-cost and power-efficient solution for a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system operating at sampling rates higher than a few Gsample/sec.…
Neuromorphic sampling is a bioinspired and opportunistic analog-to-digital conversion technique, where the measurements are recorded only when there is a significant change in the signal amplitude. Neuromorphic sampling has paved the way…
This paper addresses the problem of frequency-domain inter-carrier interference (ICI) mitigation for differential orthogonal frequency-division multiplexing (OFDM) systems. The classical fractional fast Fourier transform (F-FFT), adopting…
In this project, we wanted to discover an analog topology that could effectively convert amplitude-modulated (AM) signals to frequency-modulated (FM) signals, while also ensuring that both sets of signals were within their respective radio…
Affine frequency division multiplexing (AFDM) is a novel modulation technique based on chirp signals that has been recently proposed as an effective solution for highly reliable communications in high-mobility scenarios. In this paper, we…
In this correspondence, we analytically characterize the benefit of digital processing in uplink massive multiple-input multiple-output (MIMO) with sub-connected hybrid architecture. By assuming that the number of radio frequency (RF)…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
This paper investigates the effects of setting the sampling frequency significantly higher than conventional guidelines in system identification. Although continuous-time identification methods resolve the numerical difficulties encountered…
Modulo sampling and dithered one-bit quantization frameworks have emerged as promising solutions to overcome the limitations of traditional analog-to-digital converters (ADCs) and sensors. Modulo sampling, with its high-resolution approach…