Related papers: LoneSTAR: Analog Beamforming Codebooks for Full-Du…
This paper develops a novel methodology for designing analog beamforming codebooks for full-duplex millimeter wave (mmWave) transceivers, the first such codebooks to the best of our knowledge. Our design reduces the self-interference…
In full-duplex millimeter-wave (mmWave) systems, the effects of beam squint and the frequency-selectivity of self-interference exacerbate over wide bandwidths. This complicates the use of beamforming to cancel self-interference when…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
In this study, we analyze the codebook design used for analog beamforming. Analog beamforming and combining suffer from a subspace sampling limitation, that is, the receiver cannot directly observe the channel coefficients; instead, the…
Noteworthy strides continue to be made in the development of full-duplex millimeter wave (mmWave) communication systems, but most of this progress has been built on theoretical models and validated through simulation. In this work, we…
In this paper, we propose an analog beamsteering approach for enabling flexible hybrid beamforming design that can achieve performance close to singular value decomposition (SVD) based digital beamforming with single user case. As a…
In pursuance of the unused spectrum in higher frequencies, millimeter wave (mmWave) bands have a pivotal role. However, the high path-loss and poor scattering associated with mmWave communications highlight the necessity of employing…
Scaling the number of antennas up is a key characteristic of current and future wireless communication systems. The hardware cost and power consumption, however, motivate large-scale MIMO systems, especially at millimeter wave (mmWave)…
Millimeter wave (mmWave) and terahertz MIMO systems rely on pre-defined beamforming codebooks for both initial access and data transmission. Being pre-defined, however, these codebooks are commonly not optimized for specific environments,…
Modern millimeter wave (mmWave) communication systems rely on beam alignment to deliver sufficient beamforming gain to close the link between devices. We present a novel beam selection methodology for multi-panel, full-duplex mmWave…
The use of the millimeter (mm) wave spectrum for next generation (5G) mobile communication has gained significant attention recently. The small carrier wavelengths at mmwave frequencies enable synthesis of compact antenna arrays, providing…
Beam codebooks are integral components of the future millimeter wave (mmWave) multiple input multiple output (MIMO) system to relax the reliance on the instantaneous channel state information (CSI). The design of these codebooks, therefore,…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
A beam codebook of 5G millimeter wave (mmWave) for data communication consists of multiple high-peak-gain beams to compensate the high pathloss at the mmWave bands. These beams also have to point to different angular directions, such that…
Beamforming is a signal processing technique where an array of antenna elements can be steered to transmit and receive radio signals in a specific direction. The usage of millimeter wave (mmWave) frequencies and multiple input multiple…
The recent attempts to realize full-duplex (FD) communications in millimeter wave (mmWave) systems have garnered a significant amount of interest for its potential. In this paper, we present a cost-efficient design of mmWave FD systems,…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
Supporting high mobility in millimeter wave (mmWave) systems enables a wide range of important applications such as vehicular communications and wireless virtual/augmented reality. Realizing this in practice, though, requires overcoming…
Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…