Related papers: Suppressing data anomalies of gravitational refere…
A crucial challenge to the ongoing endeavor of spaceborne gravitational wave (GW) detection resides in the laser phase noise, typically 7 to 8 orders of magnitude above the inevitable noise. The arm locking technique was proposed to…
In an effort to eliminate laser phase noise in laser interferometer spaceborne gravitational wave detectors, several combinations of signals have been found that allow the laser noise to be canceled out while gravitational wave signals…
Space-based interferometric gravitational wave instruments such as the ESA/NASA Laser Interferometer Space Antenna (LISA) observe gravitational waves by measuring changes in the light travel time between widely-separated spacecraft. One…
Context. Galactic binaries account for the loudest combined continuous gravitational wave signal in the Laser Interferometer Space Antenna (LISA) band, which spans a frequency range of 0.1 mHz to 1 Hz. Aims. A superposition of low frequency…
We consider a recent scheme of gravitational wave detection using atomic interferometers as inertial sensors, and reinvestigate its configuration using the concept of sensitivity functions. We show that such configuration can suppress noise…
Variations in the instrumental noise of the Laser Interferometer Space Antenna (LISA) over time are expected as a result of e.g. scheduled satellite operations or unscheduled glitches. We demonstrate that these fluctuations can be leveraged…
Data from the Laser Interferometer Space Antenna (LISA) is expected to be dominated by frequency noise from its lasers. However the noise from any one laser appears more than once in the data and there are combinations of the data that are…
The space-borne gravitational wave observatory is to detect low-frequency gravitational wave signals in the range of 0.1 mHz to 100 mHz. The inertial sensors of space gravitational wave require very high accuracy for acceleration noise, and…
The increasing sensitivity of gravitational-wave detectors has brought about an increase in the rate of astrophysical signal detections as well as the rate of "glitches"; transient and non-Gaussian detector noise. Temporal overlap of…
The detection of galactic binaries as sources of gravitational waves promises an unprecedented wealth of information about these systems, but also raises several challenges in signal processing. In particular the large number of expected…
A common problem to signal processing are biases introduced by correlated noise. When quantifying time delays between two signals, mixed noise introduces a bias towards zero delay in conventional delay estimates based on the cross- or…
Time-Delay Interferometry (TDI) is the data processing technique that cancels the large laser phase fluctuations affecting the one-way Doppler measurements made by unequal-arm space-based gravitational wave interferometers. In a previous…
Tilt-to-length (TTL) noise induced by angular jitter of spacecraft and test masses can affect the sensitivity of space-based gravitational-wave detectors such as LISA, Taiji, and TianQin. Such angular jitter can be measured using the…
Spaceborne gravitational-wave observatories utilize a postprocessing technique known as time-delay interferometry (TDI) to reduce the otherwise overwhelming laser frequency noise by around 8 orders of magnitude. While, in its traditional…
Time-Delay Interferometry (TDI) is the data processing technique that cancels the large laser phase fluctuations affecting the one-way Doppler measurements made by unequal-arm space-based gravitational wave interferometers. By taking finite…
We previously showed how the measurements of some eighteen time series of relative frequency or phase shifts could be combined (1) to cancel the phase noise of the lasers, (2) to cancel the Doppler fluctuations due to non-inertial motions…
In substations, the presence of random transient impulsive interference sources makes noise highly non-Gaussian. In this paper, the primary interest is to provide a general model for wireless channel in presence of these transient impulsive…
Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…
When ambient seismic waves pass near an interferometric gravitational-wave detector, they induce density perturbations in the earth which produce fluctuating gravitational forces on the interferometer's test masses. These forces mimic a…
High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made…