Related papers: Controlling Flow Separation over a Curved Ramp Usi…
This work uncovers the low-dimensional nature the complex dynamics of actuated separated flows. Namely, motivated by the problem of model-based predictive control of separated flows, we identify the requirements on a model-based observer…
For sufficiently slow rates of strain, flowing foam can exhibit inhomogeneous flows. The nature of these flows is an area of active study in both two-dimensional model foams and three dimensional foam. Recent work in three-dimensional foam…
The separated flow response to single and multiple burst mode actuation over a 2-D airfoil at $12^o$ angle of attack was studied experimentally. For the single-burst actuation case, surface pressure signals were correlated with the…
The present study stems from the realization that the general problem relating to the analysis of wind-induced vibrations in suspension bridges still requires significant attention. Sidewalk railings, overhaul tracks, and deflectors are…
We conduct an active flow control (AFC) study on the mass flow rate of synthetic jets on the upper and lower surfaces of a square cylinder using a deep reinforcement learning (DRL) algorithm, with a focus on investigating the influence of…
Freeway on-ramps are typical bottlenecks in the freeway network due to the frequent disturbances caused by their associated merging, weaving, and lane-changing behaviors. With real-time communication and precise motion control, Connected…
The effects of sweep angle and reduced frequency on the leading-edge vortex (LEV) structure over flapping swept wings in the Reynolds number ($Re$) range of $\mathbf{O}(10^4)$ are yet to be completely understood. With increasing interest in…
We analyze the interaction of a radiation-dominated jet and its surroundings using the equations of radiation hydrodynamics in the viscous limit. In a previous paper we considered the two-stream scenario, which treats the jet and its…
The impact of turbulent fluctuations on the forces exerted by a fluid on a towed spherical particle is investigated by means of high-resolution direct numerical simulations. The measurements are carried out using a novel scheme to integrate…
We perform direct numerical simulations (DNS) of actively controlled laminar separated wakes around low-aspect-ratio wings with two primary goals: (i) reducing the size of the separation bubble and (ii) attenuating the wing tip vortex.…
We carried out high-resolution large-eddy simulations (LESs) to investigate the effects of several separation-control approaches on a NACA4412 wing section with spanwise width of $L_z = 0.6$ at an angle of attack of $AoA=11^{\circ}$ at a…
The present paper numerically investigates flow control over NACA0021 (National Advisory Committee for Aeronautics) airfoil by applying a leading-edge tubercle as a passive flow control device at transitional Reynolds number (Re) regime.…
This study experimentally and numerically investigates the dynamics of a high-speed liquid jet generated from the interaction of two tandem cavitation bubbles, termed bubble 1 and bubble 2, depending on their generation sequence. In our…
The objective of this computational study is to quantify the influence of wall-normal and angular momentum injections in suppressing laminar flow separation over a canonical airfoil. Open-loop control of fully separated, incompressible flow…
This study investigates active flow control in two-dimensional flows at a Reynolds number of 100 using Deep Reinforcement Learning (DRL). We utilize DRL to develop flow control strategies that enhance energy efficiency and minimize energy…
Ejectors are used in various engineering systems, including steam and vapor compression cycles. Optimizing the performance of ejectors requires understanding and analysis of multiphase and turbulent flow structures associated with their…
The present work studied various models for predicting turbulence in the problem of injecting a fluid microjet into the boundary layer of a turbulent flow. For this purpose, the one-equation Spalart-Allmaras (SA), two-equation k-$\epsilon$…
Outflow boundaries play an important role in multiphase fluid dynamics simulations that involve transition between liquid and vapor phases. These flows are dominated by low Weber numbers and a sharp jump in pressure, velocity, and…
We present a deep reinforcement learning approach to a classical problem in fluid dynamics, i.e., the reduction of the drag of a bluff body. We cast the problem as a discrete-time control with continuous action space: at each time step, an…
Jet impingement enhances heat transfer and is characterised by the complex flow patterns formed when a jet impacts a plate aligned normal to it. While traditional round jet impingement has been extensively studied to understand flow and…