Related papers: Performance Analysis of Self-Interference Cancella…
Uplink power control is an efficient scheme to mitigate pilot contamination in massive multiple-input multiple-output (MIMO) systems. In this work, we provide a comprehensive study on the effects of fractional power control (FPC) on the…
Both antenna selection and spatial modulation allow for low-complexity MIMO transmitters when the number of RF chains is much lower than the number of transmit antennas. In this manuscript, we present a quantitative performance comparison…
We consider a multi-cell massive MIMO system where a time-division duplex protocol is used to estimate the channel state information via uplink pilots. When maximum ratio combining (MRC) is used at the BSs, the re-use of pilots across cells…
Large multiple-input multiple-output (MIMO) networks promise high energy efficiency, i.e., much less power is required to achieve the same capacity compared to the conventional MIMO networks if perfect channel state information (CSI) is…
Massive multiple-input multiple-output (MIMO) systems deploying a large number of antennas at the base station considerably increase the spectrum efficiency by serving multiple users simultaneously without causing severe interference.…
To fully unlock the benefits of multiple-input multiple-output (MIMO) networks, downlink channel state information (CSI) is required at the base station (BS). In frequency division duplex (FDD) systems, the CSI is acquired through a…
In-band Full-Duplex (FD) Multiple-Input Multiple-Output (MIMO) systems offer a significant opportunity for Integrated Sensing and Communications (ISAC) due to their capability to realize simultaneous signal transmissions and receptions.…
We consider channel estimation for an uplink massive multiple-input multiple-output (MIMO) system where the base station (BS) uses an array with low-resolution (1-2 bit) analog-to-digital converters and a spatial Sigma-Delta…
When operating massive multiple-input multiple-output (MIMO) systems with uplink (UL) and downlink (DL) channels at different frequencies (frequency division duplex (FDD) operation), acquisition of channel state information (CSI) for…
The fundamental problem in the design of a full-duplex radio is the cancellation of the self-interference (SI) signal generated by the transmitter.Current techniques for suppressing SI rely on generating a copy of the SI signal and…
Understanding the performance of multi-user multiple-input multiple-output (MU-MIMO) systems under imperfect channel state information at the transmitter (CSIT) remains a critical challenge in next-generation wireless networks. In this…
This paper is concerned with SC/FDE for bandwidth-efficient uplink block transmission, with QAM schemes, in a MU MIMO system. The number of BS receiver antennas is assumed to be large, but not necessarily much larger than the overall number…
Massive multiple-input multiple-output (MIMO) is one of the key technologies in future generation networks. Owing to their considerable spectral and energy efficiency gains, massive MIMO systems provide the needed performance to cope with…
In this paper, we investigate the uplink transmit power optimization problem in cell-free (CF) extremely large-scale multiple-input multiple-output (XL-MIMO) systems. Instead of applying the traditional methods, we propose two signal…
Massive multiple-input multiple-output (MIMO) is a promising technology for next generation wireless communication systems (5G). In this technology, Base Station (BS) is equipped with a large number of antennas. Employing high resolution…
In this work, we address the challenge of accurately obtaining channel state information at the transmitter (CSIT) for frequency division duplexing (FDD) multiple input multiple output systems. Although CSIT is vital for maximizing spatial…
Wireless systems with inband full-duplex transceiver typically require multiple lines of defense against the effect of harsh self-interference, specifically, to avoid saturation of the analog-to-digital converter (ADC) in the receiver. We…
In this paper, we propose a joint transceiver beamforming design to simultaneously mitigate self-interference (SI) and partial inter-node interference for full-duplex multiple-input and multiple-output ad-hoc network, and then derive the…
One challenge for FDD massive MIMO communication system is how to obtain the downlink channel state information (CSI) at the base station. Except for traditional codebook feedback through uplink pilot transmission, some channel reciprocity…
In-band full-duplex (FD) communication provides a promising alternative to half-duplex (HD) for wireless systems, due to increased spectral efficiency and capacity. In this paper, HD and FD radio implementations of two way, two hop and two…