Related papers: Sharp Analysis of RLS-based Digital Precoder with …
Low peak-to-average power ratio (PAPR) transmission is an important and favorable requirement prevalent in radar and communication systems, especially in transmission links integrated with high power amplifiers. Meanwhile, motivated by the…
This paper considers the joint precoder design problem for multiple-input single-output (MISO) systems with coordinated base stations (BSs). We consider maximization of the total sum rate with per BS antenna power constraint problem. For…
This work focuses on distributed linear precoding when users transmit correlated information over a fading Multiple-Input and Multiple-Output Multiple Access Channel. Precoders are optimized in order to minimize the sum-Mean Square Error…
We consider the downlink scenario of multiuser multiple-input-single-output (MU-MISO) communication systems with constant envelope (CE) signals emitted from each antenna. This results in energy efficient power amplifiers (PAs). We propose a…
The evolution of 5G New Radio (NR) has brought significant improvements in signal strength and service quality for users. By integrating Multiple Input Multiple Output (MIMO) systems into communications, multiple data streams can be…
Multi-input multi-output orthogonal frequency division multiplexing (MIMO OFDM) is a key technology for mobile communication systems. However, due to the issue of high peak-to-average power ratio (PAPR), the OFDM symbols may suffer from…
The massive multiple-input multiple-output (MIMO) transmission technology has recently attracted much attention in the non-geostationary, e.g., low earth orbit (LEO) satellite communication (SATCOM) systems since it can significantly…
Massive multiple-input multiple-output (MIMO) is a key technology for 5G wireless communications with a promise of significant capacity increase. The use of low-resolution data converters is crucial for massive MIMO to make the overall…
In this paper, we consider the precoder design for an under-loaded or critically loaded downlink multi-user multiple-input multiple-output (MU-MIMO) communication system. We propose novel precoding and decoding schemes which enhance system…
We consider Gaussian multiple-input multiple-output (MIMO) channels with discrete input alphabets. We propose a non-diagonal precoder based on the X-Codes in \cite{Xcodes_paper} to increase the mutual information. The MIMO channel is…
Using precoding to suppress multi-user interference is a well-known technique to improve spectra efficiency in multiuser multiple-input multiple-output (MU-MIMO) systems, and the pursuit of high performance and low complexity precoding…
Massive multiple-input multiple-output (MIMO) is promising for low earth orbit (LEO) satellite communications due to the potential in enhancing the spectral efficiency. However, the conventional fully digital precoding architectures might…
In massive multiple-input multiple-output (MIMO) downlink systems, the physical implementation of the base stations (BSs) requires the use of cheap and power-efficient power amplifiers (PAs) to avoid high hardware cost and high power…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
Large MIMO systems rely on efficient downlink precoding to enhance data rates and improve connectivity through spatial multiplexing. However, currently employed linear precoding techniques, such as MMSE, significantly limit the achievable…
In this paper, we address the symbol level precoding (SLP) design problem under max-min SINR criterion in the downlink of multiuser multiple-input single-output (MISO) channels. First, we show that the distance preserving constructive…
We consider the problem of maximizing the harvested power in Multiple Input Multiple Output (MIMO) Simultaneous Wireless Information and Power Transfer (SWIPT) systems with power splitting reception. Different from recently proposed…
The primary source of nonlinear distortion in wireless transmitters is the power amplifier (PA). Conventional digital predistortion (DPD) schemes use high-order polynomials to accurately approximate and compensate for the nonlinearity of…
Consider a multiuser multiple-input multiple-output (MU-MIMO) downlink system in which the base station (BS) sends multiple data streams to multi-antenna users via symbol-level precoding (SLP), where the optimization of receive combining…
Adaptation of a wireless system to the polarization state of the propagation channel can improve reliability and throughput. This paper in particular considers polarization reconfigurable multiple input multiple output (PR-MIMO) systems,…