Related papers: Full Duplex Massive MIMO Architectures: Recent Adv…

This paper is concerned with SC/FDE for bandwidth-efficient uplink block transmission, with QAM schemes, in a MU MIMO system. The number of BS receiver antennas is assumed to be large, but not necessarily much larger than the overall number…

We present an evolution of multiple-input multiple-output (MIMO) wireless communications known as the tri-hybrid MIMO architecture. In this framework, the traditional operations of linear precoding at the transmitter are distributed across…

Recently, several working implementations of in--band full--duplex wireless systems have been presented, where the same node can transmit and receive simultaneously in the same frequency band. The introduction of such a possibility at the…

One of the key technologies for the future cellular networks is full duplex (FD)-enabled integrated access and backhaul (IAB) networks operating in the millimeter-wave (mmWave) frequencies. The main challenge in realizing FD-IAB networks is…

In this paper, we propose a transceiver architecture for full-duplex (FD) eNodeB (eNB) and FD user equipment (UE) transceiver. For FD communication,.i.e., simultaneous in-band uplink and downlink operation, same subcarriers can be allocated…

Given the high throughput requirement for 5G, merging millimeter wave technologies and multi-user MIMO seems a very promising strategy. As hardware limitations impede to realize a full digital architecture, hybrid MIMO architectures, using…

Recent advances in self-interference cancellation enable radios to transmit and receive on the same frequency at the same time. Such a full duplex radio is being considered as a potential candidate for the next generation of wireless…

We solve a sum rate maximization problem of full-duplex (FD) multiuser multiple-input multiple-output (MU-MIMO) systems. Since additional self-interference (SI) in the uplink channel and co-channel interference (CCI) in the downlink channel…

The use of full-duplex (FD) communication systems is a new way to increase spectral efficiency. For this reason, it has received serious attention in the new generation of wireless communication systems. The main challenge of FD systems is…

For a massive multiple-input multiple-output (MIMO) system, restricting the number of RF chains to far less than the number of antenna elements can significantly reduce the implementation cost compared to the full complexity RF chain…

This paper deals with SC/FDE within a MU-MIMO system where a large number of BS antennas is adopted. In this context, either linear or reduced-complexity iterative DF detection techniques are considered. Regarding performance evaluation by…

We consider a dynamic time division duplex (DTDD) enabled cell-free massive multiple-input multiple-output (CF-mMIMO) system, where each half-duplex (HD) access point (AP) is scheduled to operate in the uplink (UL) or downlink (DL) mode…

Broad beam beamforming (BF) design in multiple-input multiple-output (MIMO) can be convenient for initial access, synchronization, and sensing capabilities in cellular networks by avoiding overheads of sweeping methods while making…

Cell-Free Massive MIMO comprises a large number of distributed single-antenna access points (APs) serving a much smaller number of users. There is no partitioning into cells and each user is served by all APs. In this paper, the uplink…

Distributed multiple-input multiple-output (D\mbox{-}MIMO) is a promising technology to realize the promise of massive MIMO gains by fiber-connecting the distributed antenna arrays, thereby overcoming the form factor limitations of…

Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…

Equipping millimeter wave (mmWave) systems with full-duplex capability would accelerate and transform next-generation wireless applications and forge a path for new ones. Full-duplex mmWave transceivers could capitalize on the already…

We investigate the capacity attainable for a multiuser MIMO uplink as we scale both array size and bandwidth for regimes in which all-digital arrays incur excessive hardware complexity and power consumption. We consider a tiled hybrid…

In this article, we address the challenges of transmitter-receiver isolation in \emph{mobile full-duplex devices}, building on shared-antenna based transceiver architecture. Firstly, self-adaptive analog RF cancellation circuitry is…

One of the key features of next generation wireless communication systems will be the use of frequencies in the range 10-100GHz (aka mmWave band) in densely populated indoor and outdoor scenarios. Due to the reduced wavelength, antenna…