Related papers: Fracture of silicate glasses: Micro-cavities and c…
Despite numerous experimental and theoretical investigations of the mechanical behavior of high-capacity Si and Ge Li-ion battery anodes, our basic understanding of swelling-driven fracture in these materials remains limited. Existing…
Large fluctuations of conductivity with time are observed in a low-mobility two-dimensional electron system in silicon at low electron densities $n_s$ and temperatures. A dramatic increase of the noise power ($\propto 1/f^{\alpha}$) as…
Densified SiO2 glasses, obtained from different pressure and temperature routes have been annealed over a wide range of temperature far below the glass transition temperature (500$^\circ$C-900$^\circ$C). Hot and cold compressions were…
Using molecular dynamics computer simulations we investigate how in silica the glass transition and the properties of the resulting glass depend on the cooling rate with which the sample is cooled. By coupling the system to a heat bath with…
PbSe-doped silicate glasses were studied through wide-angle X-ray diffraction (WXRD) and small-angle neutron scattering (SANS). PbSe nanoparticles in the glasses were produced due to the secondary heat treatment at different temperatures…
Amorphous silica density at ambient pressure is known to depend on thermal history (through the quenching rate) but also, at room temperature, on the maximum pressure applied in the past. Here we show that beyond density, a mechanical…
The sol-gel silica glasses doped with copper selenide nanoparticles were studied through small-angle neutron scattering (SANS) and transmission electron microscopy. SANS intensities demonstrate the complicated dependence on the scattering…
The fracture behavior of brittle and ductile materials can be strongly influenced by thermal fluctuations, especially in micro- and nano-devices as well as in rubberlike and biological materials. However, temperature effects, in particular…
The temperature dependence of the x-ray scattering in the region below the first sharp diffraction peak was measured for silica glasses with low and high OH content (GE-124 and Corning 7980). Data were obtained upon scanning the temperature…
Metallic glasses are known to have a remarkably robust yield strength, admitting Weibull moduli as high as for crystalline engineering alloys. However, their post-yielding behavior is strongly varying, with large scatter in both flow stress…
We study a calcium aluminosilicate glass of composition (SiO2)0.60(Al2O3)0.10(CaO)0.30 by means of molecular dynamics. To this end, we conduct parallel simulations, following a consistent methodology, but using three different potentials.…
The breakup of glass and alumina plates due to planar impacts on one of their lateral sides is studied. Particular attention is given to investigating the spatial location of the cracks within the plates. Analysis based on a…
The nucleation of cavities in a homogenous polymer under tensile strain is investigated in a coarse-grained molecular dynamics simulation. In order to establish a causal relation between local microstructure and the onset of cavitation, a…
In this paper, small-angle X-ray scattering measurements are used to determine the different compressibility contributions, as well as the isothermal compressibility, in thermal equilibrium in silica glasses having different thermal…
Silica is the paradigmatic network glass-former and understanding its response to pressure is essential for comprehending the mechanical properties of silica-based materials and the behavior of silicate melts in the Earth's interior. While…
Ultimately, brittle fracture involves breaking atomic bonds. However, we still lack a clear picture of what happens in the highly deformed region around a moving crack tip. Consequently, we still cannot link nano to atomic-scale phenomena…
In the framework of topological constraint theory, network glasses are classified as flexible, stressed--rigid, or isostatic if the number of atomic constraints is smaller, larger, or equal to the number of atomic degrees of freedom. Here,…
Using atomistic computer simulations we determine the roughness and topographical features of melt-formed (MS) and fracture surfaces (FS) of oxide glasses. We find that the topography of the MS is described well by the frozen capillary wave…
A phase-field description of brittle fracture is employed in the reported four-point bending analyses of monolithic and laminated glass plates. Our aims are: (i) to compare different phase-field fracture formulations applied to thin glass…
Pattern formation induced by wrinkling is a very common phenomenon exhibited in soft-matter substrates. In all these systems wrinkles develop in presence of compressively stressed thin films lying on compliant substrates. Here we…