Related papers: Coupling Matrix-based Beamforming for Superdirecti…
A mutual coupling-aware beamforming design for continuous aperture array (CAPA)-aided multi-user systems is investigated. First, a transmit coupling kernel is characterized to explicitly capture the mutual coupling effects inherent in…
We develop sparse array receive beamformer design methods achieving maximum signal-to-interference plus noise ratio (MaxSINR) for wideband sources and jammers. Both tapped delay line (TDL) filtering and the DFT realizations to wideband…
The paper considers sparse array design for receive beamforming achieving maximum signal-to-interference plus noise ratio (MaxSINR) for both single point source and multiple point sources, operating in an interference active environment.…
We propose an efficient method for designing broad beams with spatially flat array factor and efficient power utilization for cell-specific coverage in communication systems equipped with large antenna arrays. To ensure full power…
This paper proposes an asymptotically optimal hybrid beamforming solution for large antenna arrays by exploiting the properties of the singular vectors of the channel matrix. It is shown that the elements of the channel matrix with Rayleigh…
Recently, movable antenna (MA) array becomes a promising technology for improving the communication quality in wireless communication systems. In this letter, an unmanned aerial vehicle (UAV) enabled multi-user multi-input-single-output…
In this paper, we propose a beamforming method for the calibration of the direction-independent gain of the analog chains of aperture arrays. The gain estimates are obtained by cross-correlating the output voltage of each antenna with a…
This paper presents a physics-consistent framework for bistatic sensing incorporating a 2-Dimensional (2D) waveguide-fed metasurface antenna array capable of realizing eXtremely-Large Multiple-Input Multiple-Output (XL MIMO) apertures. A…
Massive antenna arrays form physically large apertures with a beam-focusing capability, leading to outstanding wireless power transfer (WPT) efficiency paired with low radiation levels outside the focusing region. However, leveraging these…
In recent years and with introduction of 5G cellular network and communication, researchers have shown great interest in Multiple Input Multiple Output (MIMO) communication, an advanced technology. Many studies have examined the problem of…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
In this paper, we investigate the problem of jointly optimizing the waveform covariance matrix and the antenna position vector for multiple-input-multiple-output (MIMO) radar systems to approximate a desired transmit beampattern as well as…
Superdirective array may achieve an array gain proportional to the square of the number of antennas $M^2$. In the early studies of superdirectivity, little research has been done from wireless communication point of view. To leverage…
The uplink where both the transmitter and receiver can use a large antenna array is considered. This is proposed as a method of antenna offloading and connecting small cell access points (SCAP) in a Two-Tier cellular network. Due to having…
Sparse array design aided by emerging fast sensor switching technologies can lower the overall system overhead by reducing the number of expensive transceiver chains. In this paper, we examine the active sparse array design enabling the…
We consider the movable-antenna (MA) arrayenabled wireless communication with coordinate multi-point (CoMP) reception, where multiple destinations adopt the maximal ratio combination technique to jointly decode the common message sent from…
Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…
In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…