Related papers: A New Optical Model for Photomultiplier Tubes

There are 17,612 20-inch photomultiplier tubes (PMTs) installed at the Jiangmen Underground Neutrino Observatory (JUNO). Developing a precise optical model for the PMTs is crucial for enhancing the accuracy of detector simulations and…

The accurate characterization of a photomultiplier tube (PMT) is crucial in a wide-variety of applications. However, current methods do not give fully accurate representations of the response of a PMT, especially at very low light levels.…

Photomultiplier tubes (PMTs) with large-area cathodes are increasingly being used in cosmic-ray experiments to enhance detection efficiency. The optical modules (OMs) of the High-Energy Underwater Neutrino Telescope (HUNT) have employed a…

We have developed an accurate simulation model of the large 9 inch photomultiplier tubes (PMT) used in water-Cherenkov detectors of cosmic-ray induced extensive air-showers. This work was carried out as part of the development of the…

Photomultiplier tubes (PMTs) are a central component of neutrino telescopes such as IceCube and KM3NeT, and an accurate understanding and measurement of their properties is indispensable for improvements of these experiments. In this…

We report on the progress in characterization of the Hamamatsu model R11410-21 Photomultiplier tubes (PMTs) for XENON1T dark matter experiment. The absolute quantum efficiency (QE) of the PMT was measured at low temperatures down to -110…

The purpose of the present article is to offer an analytical model that can be used for the calibration of photomultiplier tubes (PMTs). The derivation of the mathematical formulae is discussed extensively and we apply this machinery to a…

Photomultiplier tubes (PMTs) are widely employed in particle and nuclear physics experiments. The accuracy of PMT waveform reconstruction directly impacts the detector's spatial and energy resolution. A key challenge arises when multiple…

We present the precision calibration of 35 Hamamatsu R11410-22 photomultiplier tubes (PMTs) with xenon scintillation light centred near 175 nm. This particular PMT variant was developed specifically for the LUX-ZEPLIN (LZ) dark matter…

The central institute of electronics (ZEA-2) in the Forschungszentrum Juelich (FZJ) has developed a system to scan the response of the photocathode of photomultiplier tubes (PMT). The PMT sits tight on a supporting structure, while a blue…

Hyper-Kamiokande, the next generation large water Cherenkov detector in Japan, is planning to use approximately 80,000 20-inch photomultiplier tubes (PMTs). They are one of the major cost factors of the experiment. We propose a novel…

We present a versatile analytic model describing Photon Detection Efficiency (PDE) for P-on-N silicon photomultipliers, with possible applications for device characterization, PDE extrapolation from limited data, simulation and design…

A simplified model is proposed based on the characteristics of the photomultiplier tube (PMT). The Model is compared to the available data, and it successes to reproduce the saturation profile of the PMT. The model also adds clarification…

Since the early days of experimental particle physics photomultipliers (PMTs) have played an important role in the detector design. Thanks to their capability of fast photon counting, PMTs are extensively used in the new-generation of…

Large-area PhotoMultiplier Tubes (PMT) allow to efficiently instrument Liquid Scintillator (LS) neutrino detectors, where large target masses are pivotal to compensate for neutrinos' extremely elusive nature. Depending on the detector light…

Photomultiplier tubes (PMTs) are widely used in astroparticle physics experiments to detect light flashes (e.g. fluorescence or Cherenkov light) from extensive air showers (EASs) initiated by statistically rare very high energy cosmic…

This paper presents a quantum efficiency measurement setup based on a 2D motorized stage, a wide spectrum xenon lamp, a beam splitter system, and two calibrated photo-diodes for measuring the quantum efficiency (QE) of photomultiplier tubes…

Silicon photomultipliers (SiPMs) have a few advantages over conventional photomultiplier tubes (PMTs) used in imaging atmospheric Cherenkov telescopes. The first notable characteristic is their higher photon detection efficiency (PDE) of up…

Photomultiplier tubes (PMTs) are widely used in particle experiments for photon detection. PMT waveform analysis is crucial for high-precision measurements of the position and energy of incident particles in liquid scintillator (LS)…

To fulfill the requirements for testing the photomultiplier tubes (PMTs) of the electromagnetic detec- tor at the Large High Altitude Air Shower Observatory (LHAASO), a multi-functional PMT test bench with a two dimensional scanning system…