Related papers: Designing Interference-Immune Doppler-TolerantWave…
This work explores Doppler information from a millimetre-Wave (mm-W) Frequency-Modulated Continuous-Wave (FMCW) scanning radar to make odometry estimation more robust and accurate. Firstly, doppler information is added to the scan masking…
In this paper, we firstly exploit the inter-user interference (IUI) and inter-cell interference (ICI) as useful references to develop a robust transceiver design based on interference alignment for a downlink multi-user multi-cell…
An important problem in cognitive radar is to enhance the estimation performance of the system by a joint design of its probing signal and receive filter using the a priori information on interference. In such cases, the knowledge of…
Nowadays, waveforms of integrated sensing and communication (ISAC) are almost based on conventional communication and sensing signal, which bounds both the communication and sensing performance. To deal with this issue, in this paper, a…
Integrating radio-sensing functionalities into future cell-free (CF) wireless networks promises efficient resource utilization and facilitates the seamless roll-out of applications such as public safety and smart infrastructure. While the…
The dual-functional radar and communication (DFRC) technique constitutes a promising next-generation wireless solution, due to its benefits in terms of power consumption, physical hardware, and spectrum exploitation. In this paper, we…
To make a good balance between performance, cost, and power consumption, a hybrid intelligent reflecting surface (IRS)-aided directional modulation (DM) network is investigated in this paper, where the hybrid IRS consists of passive and…
Millimeter-wave (mmWave) communication systems face increasing susceptibility to advanced beam-stealing attacks, posing a significant physical layer security threat. This paper introduces a novel framework employing an advanced Deep…
Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…
Controlling peak side-lobe level (PSL) is of great importance in high-resolution applications of multiple-input multiple-output (MIMO) radars. In this paper, designing sequences with good autocorrelation properties are studied. The PSL of…
Emitting phased array RF systems have to contend with an ever-increasing number of eavesdroppers as technological advancements provide lower cost and/or more capable radios. Often, eavesdroppers can accumulate sufficient information…
State-of-the-art automotive radar sensors use a Mutliple-Input Mutiple-Output (MIMO) approach to obtain a better angular resolution. Time-Division Multiplexing (TDM) scheme is commonly applied to realize the orthogonality in time at the…
Commercial automotive radars used today are based on frequency modulated continuous wave signals due to the simple and robust detection method and good accuracy. However, the increase in both the number of radars deployed per vehicle and…
Low peak-to-average power ratio (PAPR) transmission is an important and favorable requirement prevalent in radar and communication systems, especially in transmission links integrated with high power amplifiers. Meanwhile, motivated by the…
This paper investigates the downlink channels in multi-cell multi-user interfering networks. The goal is to propose close-form designs to obtain degrees of freedom (DoF) in high SNR region for the network composed of base stations (BS) as…
A full-duplex two-way relay channel with multiple antennas is considered. For this three-node network, the beamforming design needs to suppress self-interference. While a traditional way is to apply zero-forcing for self-interference…
Generalized frequency division multiplexing (GFDM) is a promising candidate waveform for next-generation wireless communication systems. However, GFDM channel estimation is still challenging due to the inherent interference. In this paper,…
Extensive research on Reconfigurable Intelligent Surfaces (RIS) has primarily focused on optimizing reflective coefficients for passive beamforming in specific target directions. This optimization typically assumes prior knowledge of the…
To relieve the interference caused by range-Doppler sidelobes in pulsed radars, we propose a new method to construct Doppler resilient complementary waveforms based on Golay codes. We design both the transmit pulse train and the receive…
In underwater acoustic (UWA) communication, orthogonal frequency division multiplexing (OFDM) is commonly employed to mitigate the inter-symbol interference (ISI) caused by delay spread. However, path-specific Doppler effects in UWA…