Related papers: Viscoplastic sessile drop coalescence
Liquid films coating vertical cylinders can form annular liquid collars which translate downwards under gravity. We investigate the dynamics of a thin viscoplastic liquid film coating the interior or exterior of a vertical cylindrical tube,…
The stretching of viscoelastic polymer solutions close to break-up can create attached drops on a filament, whose properties and dynamics are little understood. The stretching of capillary bridges and the consecutive filament, until its…
Soft substrates are deformed by liquid-vapor surface tension upon contact with liquid droplets, forming the well-known wetting ridge. This ridge dynamically propagates with the moving contact line and critically influences liquid spreading.…
The jumping-droplet condensation, namely the out-of-plane jumping of condensed droplets upon coalescence, has been a promising technical innovation in the fields of energy harvesting, droplet manipulation, thermal management, etc., yet is…
Intuitively, droplets in proximity merge when brought into contact. However, under certain conditions, they may not coalesce due to the entrapment of an interstitial gas film. Non-coalescence between water droplets has so far been observed…
The Weissenberg effect, or rod-climbing phenomenon, occurs in non-Newtonian fluids where the fluid interface ascends along a rotating rod. Despite its prominence, theoretical insights into this phenomenon remain limited. In earlier work,…
We study numerically and theoretically the gravity-driven flow of a viscous liquid film coating the inner side of a horizontal cylindrical tube and surrounding a shear-free dynamically inert gaseous core. The liquid-gas interface is prone…
In this paper we explore the numerical study. of the Nonlinear Behavior of Suspension Bridge Models. The study of suspension bridges is one of the classic problems of mechanical vibrations, one of the most famous collapses of which was that…
To investigate the link between discrete, small-scale and continuous, large scale mechanical properties of a foam, we observe its two-dimensional flow in a channel, around an elliptical obstacle. We measure the drag, lift and torque acting…
The problem of partially hinged and partially free rectangular plate that aims to represent a suspension bridge subject to some external forces (for example the wind) is considered in order to model and simulate the unstable end behavior.…
In the selective withdrawal experiment fluid is withdrawn through a tube with its tip suspended a distance S above a two-fluid interface. At sufficiently low withdrawal rates, Q, the interface forms a steady state hump and only the upper…
We study the collision dynamics of surfactant-laden droplets and compare it with that of pure water droplets, with a focus on the bridge growth rate, energy balance, and disk dynamics, distinguishing the cases of head-on and off-centre…
The rise of a single bubble confined between two vertical plates is investigated over a wide range of Reynolds numbers. In particular, we focus on the evolution of the bubble speed, aspect ratio and drag coefficient during the transition…
Soft hydraulics, which addresses the interaction between an internal flow and a compliant conduit, is a central problem in microfluidics. We analyze Newtonian fluid flow in a rectangular duct with a soft top wall at steady state. The…
In an effort to study the stability of contact lines in fluids, we consider the dynamics of an incompressible viscous Stokes fluid evolving in a two-dimensional open-top vessel under the influence of gravity. This is a free boundary…
We use direct numerical simulations and scaling arguments to study coarsening in binary fluid mixtures with a conserved order parameter in the droplet-spinodal regime -- the volume fraction of the droplets is neither too small nor symmetric…
We stabilize nematic droplets with handles against surface-tension-driven instabilities using a yield-stress material as outer fluid and study the complex nematic textures and defect structures that result from the competition between…
A wetting liquid is driven through a thin gap due to surface tension and when the gap boundaries are elastic, the liquid deforms the gap as it rises. But when the fluid boundaries are also permeable (or poroelastic), the liquid can permeate…
Liquid bridges form between particles during wet mixing with binders or by condensation due to ambient humidity. The consequences of capillary bridges can be quite drastic, creating macroscopic cohesion, as seen in sandcastles and in the…
We develop a theory for drying-induced stresses in sessile, poroelastic drops undergoing evaporation on rigid surfaces. Using a lubrication-like approximation, the governing equations of three-dimensional nonlinear poroelasticity are…