Related papers: Optical Network Design for 4G LTE
Providing high data rates is one of the big concerns in visible light communication (VLC) systems. This paper introduces a data centre design that use a VLC system for downlink communication. In this work, RYGB laser diodes (LD) are used as…
Optical communication systems have come through five orders of magnitude improvement in data rate over the last three decades. The increased demand in data traffic and the limited optoelectronic component bandwidths have led to…
Real-time low-light image enhancement on mobile and embedded devices requires models that balance visual quality and computational efficiency. Existing deep learning methods often rely on large networks and labeled datasets, limiting their…
The SPP project at TAEK will use a 352.2 MHz 4-vane Radio Frequency Quadrupole (RFQ) to accelerate H+ ions from 20 keV to 1.5 MeV. With the design already complete, the project is at the test production phase. To this effect, a so called…
The fourth generation of cell phones, marketed as 4G/LTE (Long-Term Evolution) is being quickly adopted worldwide. Given the mobile and wireless nature of the involved communications, security is crucial. This paper includes both a…
We demonstrated 22.05-THz four-band long-haul transmission with a S-to-U-band lumped repeater consisting of PPLN-based optical parametric amplifiers and EDFAs over an 80-km-span SMF link. The achieved net bitrate was 133.06 Tbps at 1040 km…
It is known that phase noise (PN) can cause link performance to degrade severely in orthogonal frequency division multiplexing (OFDM) systems, such as IEEE 802.11, 3GPP LTE and 5G. As opposed to prior PN mitigation schemes that assume…
A near-field simultaneous wireless information and power transfer (SWIPT) network is investigated, where the hybrid beamforming architecture is employed at the base station (BS) for information transmission while charging energy harvesting…
Long Term Evolution (LTE)-Wireless Local Area Network (WLAN) Path Aggregation (LWPA) based on Multi-path Transmission Control Protocol (MPTCP) has been under standardization procedure as a promising and cost-efficient solution to boost…
Future 5G and Internet of Things (IoT) applications will heavily rely on long-range communication technologies such as low-power wireless area networks (LPWANs). In particular, LoRaWAN built on LoRa physical layer is gathering increasing…
Increasing data rate in wireless networks can be accomplished through a two-pronged approach, which are 1) increasing the network flow rate through parallel independent routes and 2) increasing the user's link rate through beamforming…
Fifth generation (5G) wireless networks are expected to support very diverse applications and terminals. Massive connectivity with a large number of devices is an important requirement for 5G networks. Current LTE system is not able to…
Long Term Evolution (LTE) systems provide ubiquitous coverage for mobile communications, which makes it a promising candidate to be used as a signal source in the ambient backscatter communications. In this paper, we propose a system in…
The upcoming 3GPP global mobile communication standard 6G strives to push the technological limits of radio frequency (RF) communication even further than its predecessors: Sum data rates beyond 100 Gbit/s, RF bandwidths above 1 GHz per…
In recent years, high-speed wireless communication is in vogue. In wireless communication systems, multipath fading, delay and interference occurres by reflection or diffraction. In a high-speed wireless communication, it becomes a…
Future mobile networks will exploit unlicensed spectrum to boost capacity and meet growing user demands cost-effectively. The 3GPP has recently defined a Licensed-Assisted Access (LAA) scheme to enable global Unlicensed LTE (U-LTE)…
Haptic teleoperation typically demands sub-millisecond latency and ultra-high reliability (99.999%) in Tactile Internet. At a 1 kHz haptic signal sampling rate, this translates into an extremely high packet transmission rate, posing…
Connectivity is probably the most basic building block of the Internet of Things (IoT) paradigm. Up to know, the two main approaches to provide data access to the \emph{things} have been based either on multi-hop mesh networks using…
Heterogeneous wireless networks (HetNets) provide a means to increase network capacity by introducing small cells and adopting a layered architecture. HetNets allocate resources flexibly through time sharing and cell range…
Rural areas in the developing countries are predominantly devoid of Internet access as it is not viable for operators to provide broadband service in these areas. To solve this problem, we propose a middle mile Long erm Evolution Advanced…