Related papers: Dewetting dynamics of sheared thin polymer films: …
An evolution partial differential equation for the surface of a non-wetting single-crystal film in an attractive substrate potential is derived and used to study the dynamics of a pinhole for the varying initial depth of a pinhole and the…
We perform molecular dynamics simulations of an idealized polymer melt surrounding a nanoscopic filler particle to probe the effects of a filler on the local melt structure and dynamics. We show that the glass transition temperature $T_g$…
We study the effects of time-dependent substrate/film temperature in the deposition of a mesoscopically thick film using a statistical model that accounts for diffusion of adatoms without lateral neighbors whose coefficients depend on an…
A mathematical model is developed to analyze the growth/decay rate of surface perturbations of an ultrathin metal film on an amorphous substrate (SiO_{2}). The formulation combines the approach of Mullins [J. Appl. Phys. v30, 77, 1959] for…
We present an experimental investigation of shear elastic wave propagation along the surface of a dense granular suspension. Using an ultrafast ultrasound scanner, we monitor the softening of the shear wave velocity inside the optically…
In the present contribution we review basic mathematical results for three physical systems involving self-organising solid or liquid films at solid surfaces. The films may undergo a structuring process by dewetting,…
Molecular dynamics simulations were performed for a polymer melt. In quiescent states, the inter-chain interaction energy supported by each particle takes relatively large values persistently for long times if the particle is close to an…
Shear flow is known to induce huge density fluctuations in otherwise clear and uniform polymer solutions. This effect is rooted in the elasticity of the entangled polymer network, and can span distances over a thousand chains wide. It has…
Langevin Dynamics simulations are used to study the effect of shear on a two-dimensional colloidal crystal confined by structured parallel walls. When walls are sheared very slowly, only two or three crystalline layers next to the walls…
We use molecular dynamics simulations to study the behavior of a compressible Lennard-Jones fluid in simple shear flow in a two-dimensional nanochannel. The system is equilibrated in the fluid phase close to the triple point at which gas,…
The rupture of a liquid film due to co-flowing turbulent shear flows in the gas phase is studied using a volume-of-fluid method. To simulate this multiphase problem, we use a simplified numerical setup where the liquid film is 'sandwiched'…
Thin liquid films on surfaces are part of our everyday life, they serve e.g. as coatings or lubricants. The stability of a thin layer is governed by interfacial forces, described by the effective interface potential, and has been subject of…
A phenomenon recently coined as ``overaging'' implies a slowdown in the collective (slow) relaxation modes of a glass when a transient shear strain is imposed. We are able to reproduce this behavior in simulations of a supercooled polymer…
We revisit the fundamental problem of liquid-liquid dewetting and perform a detailed comparison of theoretical predictions based on thin-film models with experimental measurements obtained by atomic force microscopy (AFM). Specifically, we…
We report molecular dynamics simulation results on the equilibrium properties of polymer thin films adsorbed onto flat and curved substrates. We first systematically determine the contact angle of polymer droplets on flat substrates as a…
We visualize entanglements in polymer melts using molecular dynamics simulation. A bead at an entanglement interacts persistently for long times with the non-bonded beads (those excluding the adjacent ones in the same chain). The…
Using molecular dynamics simulation of a polymer glass model we investigate free-standing polymer films focusing on the in-plane shear modulus $\mu$ and the corresponding shear-stress relaxation modulus $G(t)$ as functions of temperature…
The rheology of molecular brushes remains challenging to control due to the multiple length scales and relaxation processes involved and the lack of direct observation of molecular conformation during flow. We use molecular dynamics…
Dynamic mode decomposition method is deployed to investigate the heat transfer mechanism in a compressible turbulent shear layer and shockwave. To this end, highly resolved Large Eddy Simulations are performed to explore the effect of wall…
We report on three key processes involving atomic step motion during the dewetting of thin solid films: (i) the growth of an isolated island nucleated far from a hole, (ii) the spreading of a monolayer rim, and (iii) the zipping of a…