Related papers: The Virgo O3 run and the impact of the environment
The LIGO detectors collected about 4 months of data in 2003-2004 during two science runs, S2 and S3. Several environmental and auxiliary channels that monitor the instruments' physical environment and overall interferometric operation were…
We report on the status of the Laser Interferometric Gravitational-Wave Observatory (LIGO) and the plans and progress towards Enhanced and Advanced LIGO. The initial LIGO detectors have finished a two year long data run during which a full…
The first generation of ground-based interferometric gravitational wave detectors, LIGO, GEO and Virgo, have operated and taken data at their design sensitivities over the last few years. The data has been examined for the presence of…
The Advanced Laser Interferometer Gravitational-wave Observatory (LIGO) detectors have completed their initial upgrade phase and will enter the first observing run in late 2015, with detector sensitivity expected to improve in future runs.…
The data taken by the advanced LIGO and Virgo gravitational-wave detectors contains short duration noise transients that limit the significance of astrophysical detections and reduce the duty cycle of the instruments. As the advanced…
The first two LIGO and Virgo observation runs have been important milestones in the gravitational wave (GW) field, thanks to the detection of GW signals from ten binary black hole systems and a binary neutron star system. In order to fully…
Detector characterization and data quality studies -- collectively referred to as {\em DetChar} activities in this article -- are paramount to the scientific exploitation of the joint dataset collected by the LIGO-Virgo-KAGRA global network…
The Virgo detector is a kilometer-length interferometer for gravitational wave detection located near Pisa (Italy). During its second science run (VSR2) in 2009, six months of data were accumulated with a sensitivity close to its design. In…
We present results from a search for gravitational-wave bursts in the data collected by the LIGO and Virgo detectors between July 7, 2009 and October 20, 2010: data are analyzed when at least two of the three LIGO-Virgo detectors are in…
In August 2017, Advanced Virgo joined Advanced LIGO for the end of the O2 run, leading to the first gravitational waves detections with the three-detector network. This paper describes the Advanced Virgo calibration and the gravitational…
The LIGO, VIRGO and KAGRA Gravitational-wave (GW) observatories are getting ready for their fourth observational period, O4, scheduled to begin in March 2023, with improved sensitivities and thus higher event rates. GW-related computing has…
On September 2015, a century after Einstein's predictions of their existence, the first gravitational waves (GWs) direct detection was performed by LIGO. On August 17, 2017, the two Advanced LIGO and the Advanced Virgo interferometers…
Increasing the laser power is essential to improve the sensitivity of interferometric gravitational wave detectors. However, optomechanical parametric instabilities can set a limit to that power. It is of major importance to understand and…
The LIGO and Virgo detectors are sensitive to a variety of noise sources, such as instrumental artifacts and environmental disturbances. The Stochastic Transient Analysis Multi-detector Pipeline (STAMP) has been developed to search for…
We investigate the effects of observatory locations on the probability of discovering optical/infrared counterparts of gravitational wave sources. We show that for the LIGO--Virgo network, the odds of discovering optical/infrared (OIR)…
Gravitational-wave observatories become more sensitive with each observing run, increasing the number of detected gravitational-wave signals. A limiting factor in identifying these signals is the presence of transient non-Gaussian noise,…
The gravitational wave detectors used by the LIGO Scientific Collaboration, and the Virgo Collaboration are incredibly sensitive instruments which frequently detect non-stationary, non-Gaussian noise transients. iDQ is a statistical…
The characterization of the Advanced LIGO detectors in the second and third observing runs has increased the sensitivity of the instruments, allowing for a higher number of detectable gravitational-wave signals, and provided confirmation of…
The Laser Interferometer Gravitational-Wave Observatory forms part of the international effort to detect and study gravitational waves of astrophysical origin. One of the major obstacles for this project with the first generation detectors…
After the detection of gravitational waves from compact binary coalescences, the search for transient gravitational-wave signals with less well-defined waveforms for which matched filtering is not well-suited is one of the frontiers for…