Related papers: IEC61850 Sample-Value Service Based on Reduced App…

This chapter summarizes the results obtained from a test bed, which is composed of a microgrid and a wireless network, both relying on real and practical premises. This test bed aims to evaluate application protocols considered in the…

This paper proposes and investigates an overlay spectrum sharing system in conjunction with the simultaneous wireless information and power transfer (SWIPT) to enable communications for the Internet of Things (IoT) applications. Considered…

The Internet of Things has affected all aspects of daily life, and the number of IoT devices is increasing day by day. According to forecasts, the number of Internet of Things devices will reach one trillion devices by 2035. The increase in…

In this paper, we propose a unified SWIPT signal and its architecture design in order to take advantage of both single tone and multi-tone signaling by adjusting only the power allocation ratio of a unified signal. For this, we design a…

Simultaneous wireless information and power transfer (SWIPT) has emerged as a viable technique to energize and connect low-power autonomous devices and enable future Internet of Things (IoT). A major challenge of SWIPT is the energy…

To support the development of internet-of-things applications, an enormous population of low-power devices are expected to be incorporated in wireless networks performing sensing and communication tasks. As a key technology for improving…

Enabling technologies for energy sustainable Internet of Things (IoT) are of paramount importance since the proliferation of high data communication demands of low power network devices. In this paper, we consider a Multiple Input Single…

The separate receiver architecture with a time- or power-splitting mode, widely used for simultaneous wireless information and power transfer (SWIPT), has a major drawback: Energy-intensive local oscillators and mixers need to be installed…

The proliferation of Internet of Things (IoT) networks has created an urgent need for sustainable energy solutions, particularly for the battery-constrained spatially distributed IoT nodes. While low-altitude uncrewed aerial vehicles (UAVs)…

This paper presents RF-Transformer, a unified backscatter radio hardware abstraction that allows a low-power IoT device to directly communicate with heterogeneous wireless receivers at the minimum power consumption. Unlike existing…

The IEC 61850 standard is being largely used in the Smart Grid (SG) context mainly due to its ability to address communication, interoperability and migration issues. IEC 61850 currently aims at internal substation communication.…

With the proliferation of Internet of Things (IoT) devices, ensuring secure communications has become imperative. Due to their low cost and embedded nature, many of these devices operate with computational and energy constraints, neglecting…

The efficient deployment of Internet of Things (IoT) over cellular networks, such as Long Term Evolution (LTE) or the next generation 5G, entails several challenges. For massive IoT, reducing the energy consumption on the device side…

In this paper, we present techniques and examples to reduce power consumption and increase energy efficiency of autonomous Wireless Sensor Nodes (WSNs) for the Internet of Things. We focus on the RF Energy Harvester (RFEH), the data…

In this letters, an energy-efficient integrated sensing and communication (ISAC) for space-air-ground integrated network (SAGIN)-based Internet of Things (IoT) systems is proposed to facilitate wide coverage and real-time 6G services. For…

In this paper, we propose a novel energy-efficient data collection and wireless power transfer (WPT) framework for internet of things (IoT) applications, via a multiple-input multiple-output (MIMO) full-duplex (FD) unmanned aerial vehicle…

We investigate reconfigurable intelligent surface (RIS)-assisted simultaneous wireless information and power transfer (SWIPT) Internet of Things (IoT) networks, where energy-limited IoT devices are overlaid with cellular information users…

Realizing the industrial Internet of Things, more andmore mobile use cases will emerge in the industrial landscape,requiring both novel concepts and smooth integration into legacydeployments.Since accurate time synchronization is…

The IEEE 802.15.4 is a wireless standard introduced for low power, low cost wireless communication with moderate data rates. In the next few years, it is expected that Low Rate Wireless Personal Area Networks (LR-WPAN) will be used in a…

This paper assesses the resilience of IEC 61850 digital substations under False Data Injection Attacks (FDIAs) targeting the Sampled Values (SV) protocol. The multicast nature of SV, while enabling time-critical automation, exposes…