Related papers: A Fault Location Method Using Direct Convolution: …
The possibility to have results very quickly after, or even during, the collection of electromagnetic data would be important, not only for quality check purposes, but also for adjusting the location of the proposed flight lines during an…
In power system dynamic simulation, up to 90% of the computational time is devoted to solve the network equations, i.e., a set of linear equations. Traditional approaches are based on sparse LU factorization, which is inherently sequential.…
This paper discusses a novel fault location approach using single ended measurement. The natural dissipation of the circuit parameters are considered for fault location. A relationship between the damped natural frequency of oscillation of…
In order to transmit electrical energy in a continuous and quality manner, it is necessary to control it from the point of production to the point of consumption. Therefore, protection of transmission and distribution lines is essential at…
Electrical Impedance Tomography (EIT) is a powerful imaging modality widely used in medical diagnostics, industrial monitoring, and environmental studies. The EIT inverse problem is about inferring the internal conductivity distribution of…
Symmetry is pervasive in robotics and has been widely exploited to improve sample efficiency in deep reinforcement learning (DRL). However, existing approaches primarily focus on spatial symmetries, such as reflection, rotation, and…
Precise location of faults for large distance power transmission networks is essential for faster repair and restoration process. High Voltage direct current (HVdc) networks using modular multi-level converter (MMC) technology has found its…
PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor…
A fault detection method for power conversion circuits using thermal images and a convolutional autoencoder is presented. The autoencoder is trained on thermal images captured from a commercial power module at randomly varied load currents…
This paper presents a spatiotemporal unsupervised feature learning method for cause identification of electromagnetic transient events (EMTE) in power grids. The proposed method is formulated based on the availability of time-synchronized…
We present an algorithm for focusing inversion of electrical resistivity tomography (ERT) data. ERT is a typical example of ill-posed problem. Regularization is the most common way to face this kind of problems; it basically consists in…
A blind target detector using the time reversal transmission is proposed in the presence of channel correlation. We calculate the exact moments of the test statistics involved. The derived moments are used to construct an accurate…
The high tracking overhead, the amount of up-front effort required to selecting the trace points, and the lack of effective data analysis model are the significant barriers to the adoption of intra-component tracking for fault diagnosis…
Recent advances in deep learning have produced highly accurate but increasingly large and complex DNNs, making traditional fault-injection techniques impractical. Accurate fault analysis requires RTL-accurate hardware models. However, this…
Incipient fault detection in power distribution systems is crucial to improve the reliability of the grid. However, the non-stationary nature and the inadequacy of the training dataset due to the self-recovery of the incipient fault signal,…
Extreme Learning Machines (ELM) provide a fast alternative to traditional gradient-based learning in neural networks, offering rapid training and robust generalization capabilities. Its theoretical basis shows its universal approximation…
Electromagnetic Fault Injection (EMFI) is a powerful technique for inducing bit flips and instruction-level perturbations on microcontrollers, yet existing literature lacks a unified methodology for systematically mapping spatial…
This paper proposes a non-invasive fault location method for modular multilevel converters (MMC) considering light load conditions. The prior-art fault location methods of the MMC are often developed and verified under full load conditions.…
This paper proposes a source-independent method for the detection and classification of faults along Transmission Lines (TLs). It aims to reduce the protection issues arising from Inverter-Based Resources (IBRs). Inspired by Power Line…
The inverse problem of electrical resistivity surveys (ERSs) is difficult because of its nonlinear and ill-posed nature. For this task, traditional linear inversion methods still face challenges such as suboptimal approximation and initial…