Related papers: A Sub-Picosecond Digitally-Controlled Phase Delay
We propose a paradigmatic demonstration of the potentialities of a deformable mirror for closed-loop control of a two-photon momentum-entangled state, subject to phase fluctuations. A custom-made membrane mirror is used to set a relative…
Switched capacitor arrays (SCA) ASICs are becoming more and more popular for the readout of detector signals, since the sampling frequency of typically several gigasamples per second allows excellent pile-up rejection and time measurements.…
The 7.6(5) eV nuclear magnetic-dipole transition in a single 229Th3+ ion may provide the foundation for an optical clock of superb accuracy. A virtual clock transition composed of stretched states within the 5F5/2 electronic ground level of…
I detail applications of timer interrupts in a popular micro-controller family to time critical applications in laser-cooling type experiments. I demonstrate a low overhead 1-bit frequency locking scheme and a multichannel experimental…
This paper addresses simultaneous, high-precision measurement and analysis of generic reference signals by using inexpensive commercial off-the-shelf Software Defined Radio hardware. Sine reference signals are digitally down-converted to…
Controlling femtosecond optical pulses with temporal precision better than one cycle of the carrier field has a profound impact on measuring and manipulating interactions between light and matter. We explore pulses that are carved from a…
Clock synchronization procedures are mandatory in most physical experiments where event fragments are readout by spatially dislocated sensors and must be glued together to reconstruct key parameters (e.g. energy, interaction vertex etc.) of…
Large-scale systems, such as very large accelerators used for fundamental research, require the implementation of precise timing and synchronization systems over distances of several tens of kilometers. A very high precision has been…
The experimental requirements in near future accelerators (e.g. High Luminosity-LHC) has stimulated intense interest in development of detectors with high precision timing capabilities. With this as a goal, a new detection concept called…
A Time to Digital Converter (TDC) based system, to be used for most sub-detectors in the high-flux rare-decay experiment NA62 at CERN SPS, was built as part of the NA62 fully digital Trigger and Data AcQuisition system (TDAQ), in which the…
For the submillimeter band observations, we have been routinely adopting the calibration cycle time of 20-30 minutes, which is the same as any typical centimeter and millimeter band observations. This cycle time, largely corrects only the…
In the new era of HL-LHC experiments, fast-timing detectors are emerging as critical tools for background rejection. Typical requirements include a temporal hit resolution of about 50 ps, a spatial resolution of around 12 $\mu$m, and…
This study presents a shaped reset feedback control strategy to enhance the performance of precision motion systems. The approach utilizes a phase-lead compensator as a shaping filter to tune the phase of reset instants, thereby shaping the…
The Tile Calorimeter (TileCal) is one detector of the ATLAS experiment at the Large Hadron Collider (LHC). TileCal is a sampling calorimeter made of steel plates and plastic scintillators which are readout using approximately 10,000…
Development of readout electronics for Time Projection Chamber for a Linear Collider is ongoing under stringent requirements on high channel density, lowest possible power consumption and small material budget. In the studied TPC readout…
Tunable couplers have recently become one of the most powerful tools for implementing two-qubit gates between superconducting qubits. A tunable coupler typically includes a nonlinear element, such as a SQUID, which is used to tune the…
A silicon 3D detector with a single cell of 50x50 um2 was produced and evaluated for timing applications. The measurements of time resolution were performed for 90Sr electrons with dedicated electronics used also for determining time…
The experiments at LHC are implementing novel and challenging detector upgrades for the High Luminosity LHC, among which the tracking systems. This paper reports on performance studies, illustrated by an electron trigger, using a simplified…
A dual-phase TPC (Time Projection Chamber) is more advanced in characterizing an event than a single-phase one because it can, in principle, reconstruct the 3D (X-Y-Z) image of the event, while a single-phase detector can only show a 2D…
Quantum phase transitions have been shown to be highly beneficial for quantum sensing, owing to diverging quantum Fisher information close to criticality. In this work we consider a periodically modulated Lipkin-Meshkov-Glick model to show…