Related papers: Improving the Chamberlin Digital State Variable Fi…
A new method for capacity and spectral efficiency increases is a full-duplex (FD) communication, where sending and receiving are done simultaneously. Hence, severe interference leaked from the transmitter to the receiver, which can disrupt…
Digital Signal Processing functions are widely used in real time high speed applications. Those functions are generally implemented either on ASICs with inflexibility, or on FPGAs with bottlenecks of relatively smaller utilization factor or…
Power converters require passive low-pass filters which are capable of reducing voltage ripples effectively. In contrast to signal filters, the components of power filters must carry large currents or withstand large voltages, respectively.…
FIR filters are used in many performance/power critical applications such as mobile communication devices, analogue to digital converters and digital signal processing applications. Design of appropriate FIR filters usually causes the order…
Hybrid beamforming provides a promising solution to achieve high data rate transmission at millimeter waves. Implementing hybrid beamforming at a transceiver based on available channel state information is a common solution. However, many…
Active techniques have been introduced to give better detectability performance for cyber-attack diagnosis in cyber-physical systems (CPS). In this paper, switching multiplicative watermarking is considered, whereby we propose an optimal…
Resonant periodic surfaces and films enable new functionalities with wide applicability in practical optical systems. Their material sparsity, ease of fabrication, and minimal interface count provide environmental and thermal stability and…
A novel method for distributed estimation of the frequency of power systems is introduced based on the cooperation between multiple measurement nodes. The proposed distributed widely linear complex Kalman filter (D-ACKF) and the distributed…
Conventional sub-Nyquist sampling methods for analog signals exploit prior information about the spectral support. In this paper, we consider the challenging problem of blind sub-Nyquist sampling of multiband signals, whose unknown…
A new method for designing non-uniform filter-banks for acoustic echo cancellation is proposed. In the method, the analysis prototype filter design is framed as a convex optimization problem that maximizes the signal-to-alias ratio (SAR) in…
This study presents a novel three-way unequal filtering power divider/combiner, addressing challenges in unequal power distribution while incorporating filtering functions in communication systems. Wilkinson power divider (WPD) is the…
For the first time quaternions have been used for real-time frequency estimation, where the multi-dimensional nature of quaternions allows for the full characterization of three-phase power systems. This is achieved through the use of…
Traditional quantum metrology assesses precision using the figures of merit of continuous-valued parameter estimation. Recently, quantum digital estimation was introduced: it evaluates the performance information-theoretically by…
The particle filter is one of the most successful methods for state inference and identification of general non-linear and non-Gaussian models. However, standard particle filters suffer from degeneracy of the particle weights, in particular…
This paper studies hybrid beamforming for active sensing applications, such as millimeter-wave or ultrasound imaging. Hybrid beamforming can substantially lower the cost and power consumption of fully digital sensor arrays by reducing the…
In digital signal processing time-frequency transforms are used to analyze time-varying signals with respect to their spectral contents over time. Apart from the commonly used short-time Fourier transform, other methods exist in literature,…
Data assimilation aims to estimate the states of a dynamical system by optimally combining sparse and noisy observations of the physical system with uncertain forecasts produced by a computational model. The states of many dynamical systems…
In this paper we are concerned with the error-covariance lower-bounding problem in Kalman filtering: a sensor releases a set of measurements to the data fusion/estimation center, which has a perfect knowledge of the dynamic model, to allow…
We present a sub-Nyquist analog-to-digital converter of wideband inputs. Our circuit realizes the recently proposed modulated wideband converter, which is a flexible platform for sampling signals according to their actual bandwidth…
Data assimilation is the process of estimating the state of a dynamical system over time by combining model predictions with measurements. This task becomes challenging when the system is nonlinear and high-dimensional. To address this,…