Related papers: Differential Modulation in Massive MIMO With Low-R…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
The spatial Sigma-Delta ($\Sigma\Delta$) architecture can be leveraged to reduce the quantization noise and enhance the effective resolution of few-bit analog-to-digital converters (ADCs) at certain spatial frequencies of interest.…
We propose an adaptive learning-based framework for uplink massive multiple-input multiple-output (MIMO) systems with one-bit analog-to-digital converters. Learning-based detection does not need to estimate channels, which overcomes a key…
This paper considers channel estimation and uplink achievable rate of the coarsely quantized massive multiple-input multiple-output (MIMO) system with radio frequency (RF) impairments. We utilize additive quantization noise model (AQNM) and…
In a typical Rydberg mixer, modulated communication signals are detected using a radio frequency (RF) heterodyne technique. The mixer outputs an intermediate frequency (IF), which must be filtered and mixed down to baseband. In this work,…
Use of low resolution analog to digital converters (ADCs) is an effective way to reduce the high power consumption of millimeter wave (mmWave) receivers. In this paper, a receiver with low resolution ADCs based on adaptive thresholds is…
This paper presents a low-complexity near-maximum-likelihood-detection (near-MLD) algorithm called one-bit-sphere-decoding for an uplink massive multiple-input multiple-output (MIMO) system with one-bit analog-to-digital converters (ADCs).…
Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…
Multi-input multi-output orthogonal frequency division multiplexing (MIMO OFDM) is a key technology for mobile communication systems. However, due to the issue of high peak-to-average power ratio (PAPR), the OFDM symbols may suffer from…
In this paper, we investigate symbol-level precoding (SLP) and efficient decoding techniques for downlink transmission, where we focus on scenarios where the base station (BS) transmits multiple QAM constellation streams to users equipped…
A promising approach to deal with the high hardware cost and energy consumption of massive MIMO transmitters is to use low-resolution digital-to-analog converters (DACs) at each antenna element. This leads to a transmission scheme where the…
Massive multiple-input multiple-output (MIMO) communications using low-resolution analog-to-digital converters (ADCs) is a promising technology for providing high spectral and energy efficiency with affordable hardware cost and power…
This paper proposes a variational Bayesian (VB) detector for affine frequency division multiplexing (AFDM) systems. The proposed method estimates the symbol probability distribution by minimizing the Kullback-Leibler (KL) divergence between…
Affine Frequency Division Multiplexing (AFDM), which is based on discrete affine Fourier transform (DAFT), has recently been proposed for reliable communication in high-mobility scenarios. Two low complexity detectors for AFDM are…
One of the 5G promises is to provide Ultra Reliable Low Latency Communications (URLLC) which targets an end to end communication latency that is less than 1ms . The very low latency requirement of URLLC entails a lot of work in all…
In this paper, we propose a low-complexity beamspace channel denoising algorithm for millimeter-wave (mmWave) massive multi-input multi-output (MIMO) systems with low-resolution analog-to-digital converters (ADCs). The proposed method…
In order to reduce hardware complexity and power consumption, massive multiple-input multiple-output (MIMO) systems employ low-resolution analog-to-digital converters (ADCs) to acquire quantized measurements $\boldsymbol y$. This poses new…
A novel detector for multiple-input multiple-output (MIMO) communications is presented. The algorithm belongs to the class of the lattice detectors, i.e. it finds a reduced complexity solution to the problem of finding the closest vector to…
Millimeter wave (mmWave) multi-user massive multi-input multi-output (MIMO) is a promising technique for the next generation communication systems. However, the hardware cost and power consumption grow significantly as the number of radio…
A modulation classification (MC) scheme based on Independent Component Analysis (ICA) in conjunction with either maximum likelihood (ML) or Support Vector Machines (SVM) is proposed for MIMO-OFDM signals over frequency selective, time…