Related papers: Distributed Transmit Beamforming: Design and Demon…
Distributed transmit beamforming is a technique that adjusts the signals from cooperating radios to combine coherently at a destination radio. To achieve coherent combining, the radios can exchange preambles with the destination for…
Distributed transmit beamforming enables cooperative radios to act as one virtual antenna array, extending their communications' range beyond the capabilities of a single radio. Most existing distributed beamforming approaches rely on the…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
Coordinating the operations of separate wireless systems at the wavelength level can lead to significant improvements in wireless capabilities. We address a fundamental challenge in distributed radio frequency system cooperation -…
The communication range of wireless networks can be greatly improved by using distributed beamforming from a set of independent radio nodes. One of the key challenges in establishing a beamformed communication link from separate radios is…
This paper explores the potential of near-field beamforming (NFBF) in integrated sensing and communication (ISAC) systems with extremely large-scale arrays (XL-arrays). The large-scale antenna arrays increase the possibility of having…
Cooperative beamforming (CB) has been proposed as a special case of coordinated multi-point techniques in wireless communications. In wireless sensor networks, CB can enable low power communication by allowing a collection of sensor nodes…
Coherent communications aim to support higher data rates and extended connectivity at lower power consumption compared with traditional point-to-point transmissions. The typical setting of coherent communication schemes is based on a single…
The focus of this work is on the analysis of transmit beamforming schemes with a low-rate feedback link in wireless sensor/relay networks, where nodes in the network need to implement beamforming in a distributed manner. Specifically, the…
This paper studies an unmanned aerial vehicle (UAV)-enabled wireless sensor network, in which one UAV flies in the sky to collect the data transmitted from a set of ground nodes (GNs) via distributed beamforming. We consider two scenarios…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
Unmanned Aerial Vehicles (UAVs) are being used for wireless communications in smart environments. However, the need for mobility, scalability of data transmission over wide areas, and the required coverage area make UAV beamforming…
Broad beam beamforming (BF) design in multiple-input multiple-output (MIMO) can be convenient for initial access, synchronization, and sensing capabilities in cellular networks by avoiding overheads of sweeping methods while making…
We introduce, design, and evaluate a set of universal receiver beamforming techniques. Our approach and system DEFORM, a Deep Learning (DL) based RX beamforming achieves significant gain for multi antenna RF receivers while being agnostic…
The evolution of wireless communication toward next-generation networks introduces unprecedented demands on data rates, latency, and connectivity. To meet these requirements, two key trends have emerged: the use of higher communication…
We present an adaptive approach for synchronizing both the phase and frequency of radio-frequency transceivers over long-range wireless links to support distributed antenna array applications. To enable distributed beamforming between…
We present a distributed antenna array supporting open-loop distributed beamforming at 1.5 GHz. Based on a scalable, high-accuracy internode ranging technique, we demonstrate open-loop beamforming experiments using three transmitting nodes.…
A new approach to distributed cooperative beamforming in relay networks with frequency selective fading is proposed. It is assumed that all the relay nodes are equipped with finite impulse response (FIR) filters and use a filter-and-forward…
In this paper, we present a novel distributed UAVs beam reforming approach to dynamically form and reform a space-selective beam path in addressing the coexistence with satellite and terrestrial communications. Despite the unique advantage…
As a promising technology in beyond-5G (B5G) and 6G, dual-function radar-communication (DFRC) aims to ensure both radar sensing and communication on a single integrated platform with unified signaling schemes. To achieve accurate sensing…