Related papers: Learning OFDM Waveforms with PAPR and ACLR Constra…
Oscillator phase noise (PHN) and carrier frequency offset (CFO) can adversely impact the performance of orthogonal frequency division multiplexing (OFDM) systems, since they can result in inter carrier interference and rotation of the…
This paper presents a new joint radar and communication technique based on the classical stepped frequency radar waveform. The randomization in the waveform, which is achieved by using permutations of the sequence of frequency tones, is…
Visible light communication (VLC) systems can provide illumination and communication simultaneously via light emitting diodes (LEDs). Orthogonal frequency division multiplexing (OFDM) waveforms transmitted in a VLC system will have high…
In communication systems, efficient use of the spectrum is an indispensable concern. Recently the use of compressed sensing for the purpose of estimating Orthogonal Frequency Division Multiplexing (OFDM) sparse multipath channels has been…
How to reduce the pilot overhead required for channel estimation? How to deal with the channel dynamic changes and error propagation in channel prediction? To jointly address these two critical issues in next-generation transceiver design,…
This work establishes the design, analysis, and fine-tuning of a Peak-to-Average-Power-Ratio (PAPR) reducing system, based on compressed sensing at the receiver of a peak-reducing sparse clipper applied to an OFDM signal at the transmitter.…
High-quality recordings of radio frequency (RF) emissions from commercial communication hardware in realistic environments are often needed to develop and assess spectrum-sharing technologies and practices, e.g., for training and testing…
Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…
In this paper, we devise a highly efficient machine learning-based channel estimation for orthogonal frequency division multiplexing (OFDM) systems, in which the training of the estimator is performed online. A simple learning module is…
In this paper, we propose a practical receiver for multicarrier signals subjected to a strong memoryless nonlinearity. The receiver design is based on a generalized approximate message passing (GAMP) framework, and this allows real-time…
Orthogonal frequency division multiplexing (OFDM) has been recently recognized as inadequate to meet the increased requirements of the next generation of communication systems. A number of alternative modulation solutions, based on the use…
Multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) is a key technology component in the evolution towards cognitive radio (CR) in next-generation communication in which the accuracy of timing and frequency…
Intelligent reflecting surface (IRS) is a promising new technology for achieving both spectrum and energy efficient wireless communication systems in the future. However, existing works on IRS mainly consider frequency-flat channels and…
Asymmetrically clipped optical orthogonal frequency-division multiplexing (ACO-OFDM) is a technique that sacrifices spectral efficiency in order to transmit an orthogonally frequency-division multiplexed signal over a unipolar channel, such…
A promising waveform candidate for future joint sensing and communication systems is orthogonal frequencydivision multiplexing (OFDM). For such systems, supporting multiple transmit antennas requires multiplexing methods for the generation…
Next-generation wireless networks require enhanced flexibility, efficiency, and reliability in physical layer waveform design to address the challenges posed by heterogeneous channel conditions and stringent quality-of-service demands. To…
Polynomial-cancellation-coded orthogonal frequency division multiplexing (PCC-OFDM) is a form of OFDM that has waveforms which are very well localized in both the time and frequency domains and so it is ideally suited for use in the 5G…
Orthogonal Frequency Division Multiplexing (OFDM) is the key component of many emerging broadband wireless access standards. The resource allocation in OFDM uplink, however, is challenging due to heterogeneity of users' Quality of Service…
The next generation wireless communication networks are required to support high-mobility scenarios, such as reliable data transmission for high-speed railways. Nevertheless, widely utilized multi-carrier modulation, the orthogonal…
Performing link adaptation in a multiantenna and multiuser system is challenging because of the coupling between precoding, user selection, spatial mode selection and use of limited feedback about the channel. The problem is exacerbated by…