Related papers: A direct-sampling RF receiver for MOLLER beam char…
This paper reports on the use of coherent microwave scattering (CMS) for spatially resolved electron number density measurements of elongated plasma structures induced at mid-IR femtosecond filamentation in air. The presented studies…
Accurate direct measurements of far-field thermal infrared emission become increasingly important because conventional methods, relying on indirect assessments, such as reflectance/transmittance, are inaccurate or even unfeasible to…
This paper experimentally and theoretically investigates the fundamental bounds on radio localization precision of far-field Received Signal Strength (RSS) measurements. RSS measurements are proportional to power-flow measurements…
We perform broadband phase sensitive measurements of the reflection coefficient from 45 MHz up to 20 GHz employing a vector network analyzer with a 2.4 mm coaxial sensor which is terminated by the sample under test. While the material…
A scheme of an ultra-sensitive magnetometer in the cavity quantum electromagnonics where the intracavity microwave mode coupled to a magnonic mode via magnetic dipole interaction is proposed. It is shown that by driving both magnonic and…
We propose a magnetometer for the precise measurement of AC magnetic fields that uses a Terbium-doped optical fiber with half-waveplates built into it at specified distances. Our scheme uses an open-loop quantum control technique called…
We have conducted tests at the Fermilab Booster of ionization chambers to be used as monitors of the NuMI neutrino beamline. The chambers were exposed to proton fluxes of up to 10$^{12}$ particles/cm$^2$/1.56$\mu$s. We studied space charge…
An observer based adaptive detection methodology (ADM) is proposed for estimating frequency and its rate of change (RoCoF) of the voltage and/or current measurements acquired from an instrument transformer. With guaranteed convergence and…
Radiation-hard ionization chambers were tested using an intense electron beam from the accelerator test facility (ATF) at the Brookhaven National Laboratory (BNL). The detectors were designed to be used as the basic element for monitoring…
Real-time frequency measurement for non-repetitive and statistically rare signals are challenging problems in the electronic measurement area, which places high demands on the bandwidth, sampling rate, data processing and transmission…
Diverse applications in photonics and microwave engineering require a means of measurement of the instantaneous frequency of a signal. A photonic implementation typically applies an interferometer equipped with three or more output ports to…
We propose a transmitter skew calibration based on direct detection of coherent signals with estimation errors of +/-0.2ps, providing a reliable, accurate and low-cost scheme to calibrate skew for coherent transceivers. In October 2019,…
We measure the fluorescence spectrum of broadband emitters in an open optical microcavity with radius of curvature R = 17.7(3) um and finesse F ~= 1000. This geometry enables a combined measurement of emission spectra versus cavity length,…
The calibration and traceability of high resolution frequency modulated continuous wave (FMCW) ladar sources is a requirement for their use in length and volume metrology. We report the calibration of a FMCW ladar length measurement system…
The electron transmission through a {\it closed} Aharonov-Bohm mesoscopic solid-state interferometer, with a quantum dot (QD) on one of the paths, is calculated exactly for a simple model. Although the conductance is an even function of the…
Correlation radiometers make true differential measurements in power with high accuracy and small systematic errors. This receiver architecture has been used in radio astronomy for measurements of continuum radiation for over 50 years; this…
Continuous phase modulation (CPM) with 1-bit quantization at the receiver is promising in terms of energy and spectral efficiency. In this study, CPM waveforms with symbol durations significantly shorter than the inverse of the signal…
We present an apparatus to overcome the limitations of mechanical raster-scanning in electromagnetic induction imaging (EMI) techniques by instead performing a 2D optical raster-scan within the vapour cell of a radio-frequency atomic…
The higher efficiency of superconducting radio-frequency (SRF) cavities compared to normal-conducting ones enables the development of high-energy continuous-wave linear accelerators (linacs). Recent progress in the development of…
We investigate a technique for detecting radio-frequency (RF) electric fields in a Cesium (Cs) vapor cell at room temperature by collecting charge from ionized Rydberg atoms and compare its performance with the established method of…