Related papers: Validity of solid-state Li$^+$ diffusion coefficie…
This paper presents findings on dynamic cell modeling for state-of-charge (SOC) estimation in an autonomous electric vehicle (AEV). The studied cells are Lithium-Ion Polymer-based with a nominal capacity of around 8Ah, optimized for…
Solid-state electrolytes, by enabling lithium metal anodes, may significantly increase the energy density of current lithium-ion batteries. However, similar to their liquid counterparts, these hard and stiff electrolytes can still be…
Muon spin spectroscopy ($\mu^+$SR) is now an established method to measure atomic scale diffusion coefficients of ions in oxides. This is achieved via the ion hopping rate, which causes periodic change in the local magnetic field at the…
Given the importance of continuous-time stochastic volatility models to describe the dynamics of interest rates, we propose a goodness-of-fit test for the parametric form of the drift and diffusion functions, based on a marked empirical…
Interdisciplinary collaboration in battery science is required for rapid evaluation of better compositions and materials. However, diverging domain vocabulary and non-compatible experimental results slow down cooperation. We critically…
Charge lost per unit surface area of a silicon electrode due to the formation of solid-electrolyte-interphase (SEI) layer during initial lithiation was quantified, and the species that constitute this layer were identified. Coin cells made…
Room-temperature (RT) conductivity of most candidates for solid electrolytes of miniaturized lithium-ion batteries is still 1-2 orders of magnitude below commercial requirements, therefore several approaches are being pursued aiming the…
The dielectric response and structural properties of finite-temperature electron liquids are central to accurately describing the physical behavior of electronic systems. This study presents a robust analytical model for the static…
Density functional calculations are carried out to understand and tailor the electrochemical profile diffusivity, band gap and open circuit voltage of transition metal doped olivine phosphate $LiFe_{1-x}M_{x}PO_{4}$ (M = V, Cr, Mn, Co and…
When particles/molecules diffuse in systems that contain obstacles, the steady-state regime (during which the mean-square displacement scales linearly with time, $\left< r^2 \right> \sim t$) is preceded by a transient regime. It is common…
Accurate determination of electronic properties of correlated oxides remains a significant challenge for computational theory. Traditional Hubbard-corrected density functional theory (DFT+U) frequently encounters limitations in precisely…
A nonequilibrium thermodynamic model is presented for the nonisothermal lithium-ion battery cell. Coupling coefficients, all significant for transport of heat, mass, charge and chemical reaction, were used to model profiles of temperature,…
Graphite fluoride (CFx) cathodes coupled with lithium anodes yield one of the highest theoretical energy densities (>860 Wh/g) among primary batteries. In practice, the observed discharge voltage (~2.5 V) is significantly lower than…
Self-similar solutions of the coherent diffusion equation are derived and measured. The set of real similarity solutions is generalized by the introduction of a nonuniform phase surface, based on the elegant Gaussian modes of optical…
The electrochemical permeation test is one of the most used methods for characterising hydrogen diffusion in metals. The flux of hydrogen atoms registered in the oxidation cell might be fitted to obtain apparent diffusivities. The magnitude…
Battery aging is a natural process that contributes to capacity and power fade, resulting in a gradual performance degradation over time and usage. State of Charge (SOC) and State of Health (SOH) monitoring of an aging battery poses a…
We presents an approach for early cycle classification of lithium-ion batteries into high and low-performing categories, coupled with the prediction of their remaining useful life (RUL) using a linear lasso technique. Traditional methods…
We have demonstrated a fiber lithium ion battery (LIB) fabricated by co-twisting a LiFePO4 composite-coated copper wire (cathode) together with an aluminum wire (anode). An all-solid LiPF6 composite layer functioning both as the electrolyte…
Lithium ion batteries have been a central part of consumer electronics for decades. More recently, they have also become critical components in the quickly arising technological fields of electric mobility and intermittent renewable energy…
Development generating diffraction-related valuable expressions and formulas capable of initiating new era for diffraction and for scientific domains that use it provided. The main expression, among these, gives diffracted intensity as…