Related papers: Inverse Kinematics and Dexterous Workspace Formula…
We present object handling and transporting by a multi-robot team with a deformable sheet as a carrier. Due to the deformability of the sheet and the high dimension of the whole system, it is challenging to clearly describe all the possible…
Robotic manipulators are often designed with more actuated degrees-of-freedom than required to fully control an end effector's position and orientation. These "redundant" manipulators can allow infinite joint configurations that satisfy a…
This paper presents ETA-IK, a novel Execution-Time-Aware Inverse Kinematics method tailored for dual-arm robotic systems. The primary goal is to optimize motion execution time by leveraging the redundancy of both arms, specifically in tasks…
In-situ aeroengine maintenance works are highly beneficial as it can significantly reduce the current maintenance cycle which is extensive and costly due to the disassembly requirement of engines from aircrafts. However, navigating in/out…
This paper considers a combination of actuation tendons and measurement strings to achieve accurate shape sensing and direct kinematics of continuum robots. Assuming general string routing, a methodical Lie group formulation for the shape…
This paper explores the possibility of improving bilateral robot manipulation task performance through optimizing the robot morphology and configuration of the system through motion. To optimize the design for different scenarios, we select…
This paper presents the kinematic analysis of the 3-PPPS parallel robot with an equilateral mobile platform and a U-shape base. The proposed design and appropriate selection of parameters allow to formulate simpler direct and inverse…
We present a new framework for prioritized multi-task motion-force control of fully-actuated robots. This work is established on a careful review and comparison of the state of the art. Some control frameworks are not optimal, that is they…
The motion control of wheeled mobile robots at high speeds under adverse ground conditions is a difficult task, since the robots' wheels may be subject to different kinds of slip. This work introduces an adaptive kinematic controller that…
Cable-driven continuum robots (CDCRs) are widely used in surgical and inspection tasks that require dexterous manipulation in confined spaces. Existing model-based estimation methods either assume constant curvature or rely on…
We introduce a new, analytical method for generating whole-body motions for humanoid robots, which approximate the desired Composite Rigid Body (CRB) inertia. Our approach uses a reduced five mass model, where four of the masses are…
Collaborative robots should ideally use low torque actuators for passive safety reasons. However, some applications require these collaborative robots to reach deep into confined spaces while assisting a human operator in physically…
The paper focuses on the redundancy resolution in kinematic control of a new type of serial manipulator composed of multiple tensegrity segments, which are moving in a multi-obstacle environment. The general problem is decomposed into two…
To build commercial robots, skid-steering mechanical design is of increased popularity due to its manufacturing simplicity and unique mechanism. However, these also cause significant challenges on software and algorithm design, especially…
In this paper, we propose a novel vision-based control algorithm for regulating the whole body shape of extensible multisection soft continuum manipulators. Contrary to existing vision-based control algorithms in the literature that…
A prioritized inverse kinematics (PIK) solution can be considered as a (regulation or output tracking) control law of a dynamical system with prioritized multiple outputs. We propose a method that guarantees that a joint trajectory…
Continuum robots (CR) offer excellent dexterity and compliance in contrast to rigid-link robots, making them suitable for navigating through, and interacting with, confined environments. However, the study of path planning for CRs while…
For almost all tendon-driven continuum robots, a segment is actuated by three or four tendons constrained by its mechanical design. For both cases, methods to account for the constraints are known. However, for an arbitrary number of…
One of the most challenging issues in adaptive control of robot manipulators with kinematic uncertainties is requirement of the inverse of Jacobian matrix in regressor form. This requirement is inevitable in the case of the control of…
Robots are strongly expected as a means of replacing human tasks. If a robot has a human-like physicality, the possibility of replacing human tasks increases. In the case of household service robots, it is desirable for them to be on a…