Related papers: Lumped circuit model for inductive antenna spin-wa…
We report on the dependence of curvilinear shaped coplanar waveguides on the near-field diffraction patterns of spin waves propagating in perpendicularly magnetized thin films. Implementing the propagating spin waves spectroscopy techniques…
We analytically derive a rigorous expression for the relative impedance ratio between two photonic structures based on their electromagnetic interaction. Our approach generalizes the physical meaning of the impedance to a measure for the…
Kinetic inductance travelling wave parametric amplifiers (KI-TWPAs) have been simulated using Keysight's Advanced Design System (ADS). A lumped element representation of a superconducting transmission line has been developed using nonlinear…
Superconducting parametric amplifiers have great promise for quantum-limited readout of superconducting qubits and detectors. Until recently, most superconducting parametric amplifiers had been based on resonant structures, limiting their…
It has been shown that a small discontinuity such as an enlargement or a hole on circular waveguides can produce trapped electromagnetic modes with frequencies slightly below the waveguide cutoff. The trapped modes due to multiple…
This work examines the impact of electromagnetic cross-talk in magnonic devices when using inductive spin-wave (SW) transducers. We present detailed electrical SW spectroscopy measurements showing the signal contributions to be considered…
We have fabricated and investigated a stacked two-chip device, consisting of a lumped element resonator on one chip, which is side-coupled to a coplanar waveguide transmission line on a second chip. We present a full model to predict the…
A new spin photonic topological insulator model with a 30-degree rhombic unit cell is presented and analyzed. Topological band gaps and the robustness against the defects are shown. The edge modes are studied via full-wave simulation of a…
We have investigated spin-wave excitations in rolled-up Permalloy microtubes using microwave absorption spectroscopy. We find a series of quantized azimuthal modes which arise from the constructive interference of Damon-Eshbach type spin…
In this article we present an experimental study of microwave resonators made out of Josephson junctions. The junctions are embedded in a transmission line geometry so that they increase the inductance per length for the line. By comparing…
Excitation of spin waves is considered in a superconducting ferromagnetic slab with the equilibrium magnetization both perpendicular and parallel to the surface. The surface impedance is calculated and its behavior near propagation…
In the first part of our theoretical study of correlated atomic wires on substrates, we introduced lattice models for a one-dimensional quantum wire on a three-dimensional substrate and their approximation by quasi-one-dimensional effective…
The wire method is a more rapid and less costly method to measure impedances of RF components compared to methods using a beam. A setup using a single displaced wire to excite and measure transverse resonant modes in accelerating structures…
Conventional magnonic devices use three classes of magnetostatic waves that require detailed manipulation of magnetization structure that makes the design and the device/circuitry scalability difficult tasks. Here, we demonstrate that…
Utilization of spin-wave transducers for radio-frequency signal processing provides significant potential due to intrinsic tunability, scalability and nonlinearity. However, such components can exhibit passband ripples diminishing their…
A popular absorbing structure, often referred to as Perfect Metamaterial Absorber, comprising metallic periodic pattern over a thin low-loss grounded substrate is studied by resorting to an efficient transmission line model. This approach…
The infuence of the conduction-electron spin magnetization density, induced in a two-dimensional electron layer by a microwave electromagnetic field, on the rejection and transmission of the field is considered. Because of the induced…
In a recent paper, we combined the technique of bosonization with the concept of a Rayleigh dissipation function to develop a model for resistances in one-dimensional systems of interacting spinless electrons [arXiv:1011.5058]. We also…
We use spin torque ferromagnetic resonance to measure the spectral properties of dipole-exchange spin waves in permalloy nanowires. Our measurements reveal that geometric confinement has a profound effect on the damping of spin waves in the…
In the design and investigation of superconducting qubits and related devices, a lumped element circuit model is the standard theoretical approach. However, many important physical questions lie beyond its scope, e.g. the behavior of…