Related papers: Helfrich-Hurault elastic instabilities driven by g…
The extremely low solubility of helium in liquid metals may lead to rapid supersaturation, promoting spontaneous formation of helium bubbles by nucleation. Once nucleated, the stability of these bubbles is governed by the properties of the…
The linear stability of stratified two-phase flows in rectangular ducts is studied numerically. The linear stability analysis takes into account all possible infinitesimal three-dimensional disturbances and is carried out by solution of the…
Bundles of filaments are subject to geometric frustration: certain deformations (e.g. bending while twisted) require longitudinal variations in spacing between filaments. While bundles are common -- from protein fibers to yarns -- the…
Substrates which are chemically or topographically patterned induce a variety of liquid crystal textures. The response of the liquid crystal to competing surface orientations, typical of patterned substrates, is determined by the anisotropy…
Helices are not generic outcomes of polymer collapse. Collapsed conformations of semiflexible polymers with isotropic attractions typically form globules, toroids, or rod-like structures, as seen in simulations and described by…
Non-conservative loads of the follower type are usually believed to be the source of dynamic instabilities such as flutter and divergence. It is shown that these instabilities (including Hopf bifurcation, flutter, divergence, and…
We study cholesteric order in liquid crystal shells with planar degenerate anchoring. We observe that the bipolar and radial configurations intensively reported for bulk droplets have a higher degree of complexity when the liquid crystal is…
A linear stability analysis of the hydrodynamic equations with respect to the homogeneous cooling state is performed to study the conditions for stability of a suspension of solid particles immersed in a viscous gas. The dissipation in such…
We discuss the behavior of a crystalline surface with a disordered substrate. We focus on the possible existence of a {\em super-rough} glassy phase, with height-height correlation functions which vary as the square logarithm of the…
The uniform director field obtained for the nematic ground state of the hard-rod model of liquid crystals in two dimensions reflects the high symmetry of the constituents of the liquid; It is a manifestation of the constituents' local…
Flow-induced failure of granular materials is relevant to a broad range of geomechanical applications. Plasticity, which is the inherent failure mechanism of most granular materials, enables large deformations that can invalidate linearised…
Dislocations in soft condensed matter systems such as lamellar systems of polymers, liquid crystals and ternary mixtures of oil, water and surfactant (amphiphilic systems) are described in the framework of continuum elastic theory. These…
Hydrogels have had a profound impact in the fields of tissue engineering, drug delivery, and materials science as a whole. Due to the network architecture of these materials, imbibement with water often results in uniform swelling and…
In this letter, structural rigidity concepts are used to understand the origin of instabilities in granular aggregates. It is shown that: a) The contact network of a noncohesive granular aggregate becomes exactly isostatic in the limit of…
The Kelvin-Helmholtz (KH) instability occurring in a single shear flow configuration that is embedded in a uniform flow-aligned magnetic field, is revisited by means of high resolution two-dimensional (2D) magnetohydrodynamic (MHD)…
LP-N and HLP-N are promising high-energy-density materials. However, these materials synthesized under high pressure cannot be maintained stable at ambient conditions. The mechanism behind their instability remains unclear. Our research,…
We study the behaviour of a thin fluid filament (a rivulet) flowing in an air-filled Hele-Shaw cell. Transverse and longitudinal deformations can propagate on this rivulet, although both are linearly attenuated in the parameter range we…
Since Hertz's pioneering work in 1882, contact mechanics traditionally grounds on linear elasticity, assuming small strains and displacements. However, recent experiments clearly highlighted linear elasticity limitations in accurately…
Instabilities in thin elastic sheets, such as wrinkles, are of broad interest both from a fundamental viewpoint and also because of their potential for engineering applications. Nematic liquid crystal elastomers offer a new form of control…
The crystalline structure of minerals due to the highly ordered assembly of its constituent atoms, ions or molecules confers a considerable hardness and brittleness to the materials. As a result, they are generally subject to fracture. Here…