Related papers: High-performance Ba1-xKxFe2As2 superconducting joi…

The superconducting properties of copper-sheathed MgB2 wires fabricated by conventional powder-in-tube techniques and the in-situ reaction procedure are analysed. The influence of the processing conditions and initial (1+x)Mg + 2B (x = 0,…

The paper reports the first successful fabrication of MgB2 superconducting tape using a flexible metallic substrate as well as its strong pinning force, which was verified by direct measurement of transport critical current density. The…

We report large transport critical current densities observed in Ag-added (Ba,K)Fe2As2 superconducting wires prepared by an ex-situ powder-in-tube (PIT) process. The wire has a simple composite structure sheathed only by Ag. A precursor…

We have successfully synthesized a new superconducting phase of FeTe1-xSx with a PbO-type structure. It has the simplest crystal structure in iron-based superconductors. Superconducting transition temperature is about 10 K at x = 0.2. The…

Copper sheath is the first choice for manufacturing high-Tc superconducting wires and tapes because of its high electrical and thermal conductivities, low cost and good mechanical properties. However, Cu can easily react with…

Co-doped BaFe2As2 has been previously shown to have an unusually significant improvement of Tc (up to 2 K, or almost 10%) with annealing 1-2 weeks at 700 or 800 C, where such annealing conditions are insufficient to allow significant atomic…

Here we report the synthesis and discovery of superconductivity in a novel ternary iridium-arsenide compound BaIr2As2. The polycrystalline BaIr2As2 sample was synthesized by a high temperature and high pressure method. Crystal structural…

The influence of mechanical strain on the critical current (Ic) is investigated for MgB2/stainless steel (SUS316) superconducting tapes. The tapes are fabricated by using 'powder in tube' method and deformation process without any heat…

High quality Rb0.8Fe1.6+xSe2 single crystals are grown by a one step melting growth method. Superconductivity has been observed in all samples with x more than 0.05 and the maximum critical temperature Tc~32 K has been obtained in samples…

We scrutinize the enhanced superconducting performance of melt quench Bismuth based Bi2Sr2CaCu2O8 (Bi-2212) superconductor. The superconducting properties of melt quenched Bi-2212 (Bi2212-MQ) sample are compared with non-melted Bi2212-NM…

Compounds of Sr1-xLaxFe2As2 were synthesized by solid state reaction at 1273 K, under pressures of 2 or 3 GPa. The Sr1-xLaxFe2As2 phase was dominant up to x = 0.5, and superconductivity was observed at $x \ge 0.2$. A maximum critical…

Transport critical current (Ic) was measured for Fe-sheathed MgB2 round wires. A critical current density of 5.3 x 10^4 A/cm^2 was obtained at 32K. Strong magnetic shielding by the iron sheath was observed, resulting in a decrease in Ic by…

The most effective way to enhance the dissipation-free supercurrent in presence of magnetic field for type II superconductors is the introduction of defects that acts as artificial pinning centres (APCs) for the vortices. For instance, the…

Superconductivity was recently observed in the iron-arsenic-based compounds with a superconducting transition temperature (Tc) as high as 56K [1-7], naturally raising comparisons with the high Tc copper oxides. The copper oxides have…

High critical current densities (Jc) > 1 MA/cm2 were realized in cobalt-doped BaFe2As2 (BaFe2As2:Co) films on flexible metal substrates with biaxially-textured MgO base-layers fabricated by an ion-beam assisted deposition technique. The…

Ag-sheathed CaKFe4As4 superconducting tapes have been fabricated via the ex-situ powder-in-tube method. Thermal and X-ray diffraction analyses suggest that the CaKFe4As4 phase is unstable at high temperatures. It decomposes into the CaAgAs…

In the iron arsenide compound BaFe2As2, superconductivity can be induced either by a variation of its chemical composition, e.g., by replacing Fe with Co, or by a reduction of the unit-cell volume through the application of hydrostatic…

We demonstrate the fabrication of superconducting SmFeAsO1-xFx (Sm-1111) wires by using the ex-situ powder-in-tube technique. Sm-1111 powder and a binder composed of SmF3, samarium arsenide, and iron arsenide were used to synthesize the…

We report significant transport critical currents firstly achieved in Sr0.6K0.4Fe2As2 wires and tapes with a Tc = 34 K, which were fabricated through an in-situ powder-in-tube process. Silver was used as a chemical addition as well as a…

The MgB2 coated superconducting tapes have been fabricated on textured Cu (0 0 1) and polycrystalline Hastelloy tapes using coated conductor technique, which has been developed for the second generation high temperature superconducting…