Related papers: Small Signal Analysis of SQUID Direct Readout Sche…
A flux qubit readout scheme involving a dispersive technique coupled to a microstrip squid amplifier has been tested experimentally. Thanks to the almost quantum limited noise of this amplifier at low temperature, this readout device is…
We investigate the characteristics and noise performance of rf Superconducting Quantum Interference Devices (SQUIDs) by solving the corresponding Langevin equations numerically and optimizing the model parameters with respect to noise…
We have implemented a resonant circuit that uses a SQUID as a flux-sensitive Josephson inductor for qubit readout. In contrast to the conventional switching current measurement that generates undesired quasi-particles when the SQUID…
We present measurements of an amplifier operating at 3.8 GHz with 150 MHz of bandwidth based on the microstrip input-coil resonance of a dc superconducting quantum interference device (SQUID) with submicron Josephson junctions. The noise…
Designing superconducting electronic devices involves a careful study of all the elements in the circuit, including the superconducting bias leads, however, the effect of the bias current leads on the performance of the device have not been…
Using a simple lumped-circuit model, we numerically study the dependence of the voltage gain and noise on the amplifier's parameters. Linear, quasi-linear, and nonlinear regimes are studied. We have shown that the voltage gain of the…
Scanning Superconducting Quantum Interference Device (SQUID) Susceptometry simultaneously images the local magnetic fields and susceptibilities above a sample with sub-micron spatial resolution. Further development of this technique…
We present a new theoretical framework to analyze microwave amplifiers based on the dc SQUID. Our analysis applies input-output theory generalized for Josephson junction devices biased in the running state. Using this approach we express…
The peculiarities of the microstrip-DC SQUID amplifier caused by the resonant structure of the input circuit are analyzed. It is shown that the mutual inductance, that couples the input circuit and the SQUID loop, depends on the frequency…
We present a readout method for superconducting flux qubits. The qubit quantum flux state can be measured by determining the Josephson inductance of an inductively coupled DC superconducting quantum interference device (DC-SQUID). We…
Due to their superior noise performance, SQUIDs are an attractive alternative to high electron mobility transistors for constructing ultra-low-noise microwave amplifiers for cryogenic use. We describe the use of a lumped element SQUID…
Pulsed readout of Direct Current (DC) SUperconducting Quantum Interference Device (SQUID) is crucial for experiments which need to be performed at millikelvin temperatures, such as the readout of superconducting and electron spin based…
We investigate rf SQUIDs (Superconducting QUantum Interference Devices), coupled to a resonant input circuit, a readout tank circuit and a preamplifier, by numerically solving the corresponding Langevin equations and optimizing model…
A superconducting quantum interference device (SQUID), functioning as a nonlinear response device, typically requires the incorporation of a flux-locked loop (FLL) circuit to facilitate linear amplification of the current signal transmitted…
Direct-current superconducting quantum interference devices (dc-SQUIDs) are one of the most sensitive magnetic detectors. These sensors are extensively used in the readout of superconducting transition edge sensors (TESs), which are used…
We report measurements on two superconducting flux qubits coupled to a readout Superconducting QUantum Interference Device (SQUID). Two on-chip flux bias lines allow independent flux control of any two of the three elements, as illustrated…
Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit…
A particular superconducting quantum interference device (SQUID)qubit, indicated as double SQUID qubit, can be manipulated by rapidly modifying its potential with the application of fast flux pulses. In this system we observe coherent…
Flux transformers and superconducting quantum interference devices (SQUIDs) are two key superconducting devices used in the cutting-edge magnetic-field sensor systems, such as magnetocardiography (MCG) and magnetoencephalography (MEG). They…
We present measurements of an amplifier based on a dc superconducting quantum interference device (SQUID) with submicron Al-AlOx-Al Josephson junctions. The small junction size reduces their self-capacitance and allows for the use of…