Related papers: Clipping over dissipation in turbulence models
A variational technique is used to derive analytical expressions for the sensitivity of recirculation length to steady forcing in separated flows. Linear sensitivity analysis is applied to the two-dimensional steady flow past a circular…
Wall-pressure fluctuations beneath turbulent boundary layers drive noise and structural fatigue through interactions between fluid and structural modes. Conventional predictive models for the spectrum--such as the widely accepted Goody…
A large amount of published data show that particles with diameter above 10\% of the turbulence integral length scale ($D/l >0.1$) tend to increase the turbulent kinetic energy of the carrier fluid above the single-phase value, and smaller…
Modeling of wall-bounded turbulent flows is still an open problem in classical physics, with only modest progress made in the last few decades beyond the so-called `log law', which describes only the intermediate region in wall-bounded…
A shear-improved Smagorinsky model is introduced based on recent results concerning shear effects in wall-bounded turbulence by Toschi et al. (2000). The Smagorinsky eddy-viscosity is modified subtracting the magnitude of the mean shear…
In this paper the capabilities of the turbulence-resolving Eulerian-Eulerian two-phase flow model to predict the suspension of mono-dispersed finite-sized solid particles in a boundary layer flow are investigated. For heavier-than-fluid…
Low Reynolds number turbulence in wall-bounded shear flows \emph{en route} to laminar flow takes the form of oblique, spatially-intermittent turbulent structures. In plane Couette flow, these emerge from uniform turbulence via a…
A previously developed modeling procedure for large eddy simulations (LESs) is extended to allow physical space implementations for inhomogeneous flows. The method is inspired by the well-established theoretical analyses and numerical…
In this visualisation the instantaneous local velocity is expressed in terms of four components to capture the development of and interactions between coherent structures in turbulent flows. It is then possible to isolate the terms linked…
Near-wall turbulent velocities in turbulent channel flows are decomposed into small-scale and large-scale components at $y^+<100$ by improving the predictive inner-outer model of Baars et al. [Phys. Rev. Fluids 1, 054406 (2016)], where…
Turbulent drag reduction through streamwise travelling waves of spanwise wall oscillation is investigated over a wide range of Reynolds numbers. Here, in Part 1, wall-resolved large-eddy simulations in a channel flow are conducted to…
The transition to turbulence in flows where the laminar profile is linearly stable requires perturbations of finite amplitude. "Optimal" perturbations are distinguished as extrema of certain functionals, and different functionals give…
We show that the energy required by a turbulent flow to displace a given amount of fluid through a straight duct in a given time interval can be reduced by modulating in time the pumping power. The control strategy is hybrid: it is passive,…
Knowledge of turbulent flows over non-flat surfaces is of major practical interest in diverse applications. Significant work continues to be reported in the roughness regime at high Reynolds numbers where the cumulative effect of surface…
Deformation of material lines drives transport and dissipation in many industrial and natural flows. Here we report an exact Eulerian formula for the stretching rate of a material line, also known as the topological entropy, in a prototype…
Direct Numerical Simulations of turbulent channel flows at friction Reynolds number 550, 1000, 1500, are used to analyse the turbulent production, transfer and dissipation mechanisms in the compound space of scales and wall-distances by…
Scaling laws and intermittency in the wall region of a turbulent flow are addressed by analyzing moderate Reynolds number data obtained by single component hot wire anemometry in the boundary layer of a flat plate. The paper aims in…
An experiment was performed using Dual-plane-SPIV in the LMFL boundary layer facility to determine all of the derivative moments needed to estimate the average dissipation rate of the turbulent kinetic energy, $\varepsilon$, and its…
Turbulent flows consist of a wide range of interacting scales. Since the scale range increases as some power of the flow Reynolds number, a faithful simulation of the entire scale range is prohibitively expensive at high Reynolds numbers.…
A turbulent pipe flow experiment was conducted where the surface of the pipe was oscillated azimuthally over a wide range of frequencies, amplitudes and Reynolds number. The drag was reduced by as much as 30\%. Past work has suggested that…