Related papers: Modeling of A Realistic DC Source in A CVSR
The inductive charging of electric vehicles requires specific measurement and calibration systems. In fact, the measurement of power on board involves DC signals, which are superimposed to a significant AC ripple up to or over 150 kHz,…
The mixed-state resistive response of a superconductor thin film with an asymmetric washboard pinning potential subject to superimposed dc and ac currents of arbitrary amplitudes and frequency at finite temperature is theoretically…
DC microgrids are converter-based electrical networks that are increasingly being used in various applications, including data centers and industrial distribution systems. A central challenge in their operation is maintaining the DC-bus…
Heating, ventilation, and air conditioning (HVAC) systems are well proved to be capable to provide operating reserve for power systems. As a type of large-capacity and energy-efficient HVAC system (up to 100 MW), district cooling system…
A general expression of the current induced spin torque in a magnetic layered structure in the presence of external dc or ac voltages is derived in the framework of the scattering matrix approach. A detailed analysis is performed for a…
Three-phase AC-DC rectifiers are fundamental components in modern power electronics systems, yet achieving rapid voltage regulation and precise current tracking under load and grid disturbances remains challenging due to nonlinear dynamics…
Superconductor electronics fabrication technology developed at MIT Lincoln Laboratory enables the development of VLSI digital circuits with millions of Josephson junctions per square centimeter. However, conventional DC and multi-phase AC…
Teaching by direct models in science has been weakening the learning process of the students, because the real problems in engineering are not solved by direct models instead commonly they are solved by inverse models. On the other hand,…
Continuous Stirred Tank Reactors (CSTR) are the most important and central equipment in many chemical and biochemical industry that exhibit second order complex nonlinear dynamics. The nonlinear dynamics of CSTR poses many design and…
We report mesoscopic dc current generation in an open chaotic quantum dot with ac excitation applied to one of the shape-defining gates. For excitation frequencies large compared to the inverse dwell time of electrons in the dot (i.e.,…
In this paper, a new fault tolerant dc-ac converter-fed induction motor drive is proposed to maintain motor as close as possible to its desired normal operation under open- and short-circuit switch failures. The operational principles for…
This paper proposes a novel two-layer Volt/VAR control (VVC) framework to regulate the voltage profiles across an unbalanced active distribution system, which achieves both the efficient open-loop optimization and accurate closed-loop…
As the last resort of emergency control, controlled islanding is an effective means of preventing fault-propagation and a system-wide blackout. However, conventional AC transmission lines are unavailable to be employed for power exchange…
In this project we evaluate a framework for synchronization of mixed machine-converter power grids. Synchronous machines are assumed to be actuated by mechanical torque injections, while the converters by DC-side current injections. As this…
High penetration levels of distributed photovoltaic(PV) generation on an electrical distribution circuit present several challenges and opportunities for distribution utilities. Rapidly varying irradiance conditions may cause voltage sags…
This paper presents experimental and modelling results of an ultra-compact self-rectifier flux pump energizing a superconducting coil. The device fits inside a volume of 65x65x50~mm and generates up to 320~A dc through the coil and a peak…
Inverter-based distributed energy resources facilitate the advanced voltage control algorithms in the online setting with the flexibility in both active and reactive power injections. A key challenge is to continuously track the…
We theoretically propose a method of rectifying spin current with a linearly-polarized electromagnetic wave in inversion-asymmetric magnetic insulators. To demonstrate the proposal, we consider quantum spin chains as a simple example; these…
Regulating the voltage of the common DC bus, also referred to as the load bus, in DC microgrids is crucial for ensuring reliability and maintaining the nominal load voltage, which is essential for protecting sensitive loads from voltage…
In vibration energy harvesting technologies, feedback control is required to maximize the average power generated from stochastic disturbances. In large-scale applications it is often advantageous to use three-phase conversion technologies…