Related papers: Characterisation of microstructural creep, strain …
The slip strength of individual slip systems at different strain rates will control the mechanical response and strongly influence the anisotropy of plastic deformation. In this work, the slip activity and strain rate sensitivity of the <a>…
Digital image correlation of laser-ablated platinum nanoparticles on the surface of a polycrystalline metal (nickel-based superalloy Rene 88DT) was used to obtain the local strain behavior from an in situ scanning electron microscope…
Understanding the creep mechanisms and deformation response at different stresses and temperatures is crucial for design using nickel-base superalloys for high-temperature applications. In this study, the creep behaviour of a newly designed…
Synchrotron Laue microdiffraction and Digital Image Correlation measurements were coupled to track the elastic strain field (or stress field) and the total strain field near a general grain boundary in a bent bicrystal. A 316L stainless…
The viscoplastic behavior of polycrystalline Mg$_2$SiO$_4$ wadsleyite aggregates, a major high pressure phase of the mantle transition zone of the Earth (depth range: 410 -- 520 km), is obtained by properly bridging several scale transition…
A recently developed full field level-set model of continuous dynamic recrystallization is applied to simulate zircaloy-4 recrystallization during hot compression and subsequent heat treatment. The influence of strain rate, final strain and…
The interactions between {\delta}-hydrides and plastic slip in a commercial zirconium alloy, Zircaloy-4, under stress were studied using in situ secondary electron microscope (SEM) micropillar compression tests of single crystal samples and…
The present article proposes a detailed study of recrystallization of zircaloy-4 under hot forming conditions by means of experimental and numerical tools. Thermomechanical tests and characterization campaigns that have been necessary for…
The creep behaviour and microstructural evolution of a Sn-3Ag-0.5Cu wt.% sample with a columnar microstructure have been investigated through in-situ creep testing under constant stress of 30 MPa at 298 K. This is important, as 298 K is…
A systematic study of the compression creep properties of a single-crystalline Co-base superalloy (Co-9Al-7.5W-2Ta) was conducted at 950 {\deg}C, 975 {\deg}C and 1000 {\deg}C to reveal the influence of temperature and the resulting…
A micromechanical model at the microscale within a crystal plasticity self-consistent model, is used to analyse loading histories in Type 316H stainless steel, common to structural components in high-temperature power plants. The study…
Digital image correlation (DIC) and crystal plasticity simulation were utilised to study cold dwell behaviour in a coarse grain Ti-6Al alloy at 3 different temperatures up to 230 C. Strains extracted from large volume grains were measured…
Cross slip of screw dislocations in crystalline solids is a stress-driven thermally activated process essential to many phenomena during plastic deformation, including dislocation pattern formation, strain hardening, and dynamic recovery.…
There is a long standing technological problem in which a stress dwell during cyclic loading at room temperature in Ti causes a significant fatigue life reduction. It is thought that localised time dependent plasticity in soft grains…
When strain-rate sensitivity (SRS) is negative in metallic glasses, the material becomes weaker as the deformation rate increases, leading to accelerated plastic deformation and, eventually, catastrophic fracture. In this study, we…
The microstructure and mechanical properties of materials saturate to steady states after severe plastic deformation (SPD). Despite the well-known effect of temperature on the steady-state microstructure, there is no general agreement on…
Co-base superalloys are considered as promising high temperature materials besides the well-established Ni-base superalloys. However, Ni appears to be an indispensable alloying element also in Co-base superalloys. To address the influence…
The plastic deformation processes that occur in a tensily deformed High Density Polyethylene specimen were studied from full-field strain and strain rate measurements obtained by 3D DIC (Digital Image Correlation).The tensile tests were…
The nonequilibrium dynamics of diffusion-mediated plasticity and creep in materials subjected to constant load at high homologous temperatures is studied atomistically using Phase Field Crystal (PFC) methods. Creep stress and grain size…
This work presents an open source, dislocation density based crystal plasticity modeling framework, $\rho$-CP. A Kocks-type thermally activated flow is used for accounting for the temperature and strain rate effects on the crystallographic…