Related papers: 1-Bit MIMO for Terahertz Channels
The joint design of analog beamforming and power allocation is investigated for a single radio-frequency chain multiuser time-division multiple access system under a max-min signal-to-noise ratio (SNR) criterion. A hardware-efficient…
Analog to Digital Converters (ADCs) are a major contributor to the energy consumption on the receiver side of millimeter-wave multiple-input multiple-output (MIMO) systems with large antenna arrays. Consequently, there has been significant…
An energy-efficient opportunistic collaborative beamformer with one-bit feedback is proposed for ad hoc sensor networks over Rayleigh fading channels. In contrast to conventional collaborative beamforming schemes in which each source node…
Millimeter-wave (mm-wave) communication is a key technology for future wireless networks. To combat significant path loss and exploit the abundant mm-wave spectrum, effective beamforming is crucial. Nevertheless, conventional fully digital…
This work considers communication networks where individual links can be described as MIMO channels. Unlike orthogonal modulation methods (such as the singular-value decomposition), we allow interference between sub-channels, which can be…
Millimeter wave (mmWave) communication has attracted increasing attention as a promising technology for 5G networks. One of the key architectural features of mmWave is the use of massive antenna arrays at both the transmitter and the…
Massive multiple-input multiple-out (MIMO) technology is vital in millimeter-wave (mmWave) bands to obtain large array gains. However, there are practical challenges, such as high hardware cost and power consumption in such systems. A…
Hybrid analog and digital BeamForming (HBF) is one of the enabling transceiver technologies for millimeter Wave (mmWave) Multiple Input Multiple Output (MIMO) systems. This technology offers highly directional communication, which is able…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Coherent communications aim to support higher data rates and extended connectivity at lower power consumption compared with traditional point-to-point transmissions. The typical setting of coherent communication schemes is based on a single…
Microwave linear analog computer (MiLAC)-aided transmit beamforming, which processes transmitted symbols entirely in the analog domain, has recently emerged as a promising alternative to fully digital or hybrid beamforming architectures for…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
This paper proposes an adaptive multi-mode transmission strategy to improve the spectral efficiency achieved in the multiple-input multiple-output (MIMO) broadcast channel with delayed and quantized channel state information. The adaptive…
In this paper, we consider a synthetic aperture secure beamforming approach for a virtual multiple-input multiple output (MIMO) broadcast channel in the presence of hybrid wiretapping environments. Our goal is to design the flight node…
Massive multiple-input multiple-output (MIMO) has the potential to substantially improve the spectral efficiency, robustness and coverage of mobile networks. However, such potential is limited by hardware cost and power consumption…
Future wireless systems, known as gigantic multiple-input multiple-output (MIMO), are expected to enhance performance by significantly increasing the number of antennas, e.g., a few thousands. To enable gigantic MIMO overcoming the…
Motivated by massive deployment of low data rate Internet of things (IoT) and ehealth devices with requirement for highly reliable communications, this paper proposes receive beamforming techniques for the uplink of a single-input…
We study multi-user massive multiple-input single-output (MISO) systems and focus on downlink transmission, where the base station (BS) employs a large antenna array with low-cost 1-bit digital-to-analog converters (DACs). The direct…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
We present an evolution of multiple-input multiple-output (MIMO) wireless communications known as the tri-hybrid MIMO architecture. In this framework, the traditional operations of linear precoding at the transmitter are distributed across…