Related papers: Bit Density Based Signal and Jamming Detection in …
In massive multiple-input multiple-output (MIMO) systems, acquisition of the channel state information at the transmitter side (CSIT) is crucial. In this paper, a practical CSIT estimation scheme is proposed for frequency division duplexing…
We consider the problem of sparse signal recovery from 1-bit measurements. Due to the noise present in the acquisition and transmission process, some quantized bits may be flipped to their opposite states. These sign flips may result in…
The beam squint effect, which manifests in different steering matrices in different sub-bands, has been widely considered a challenge in millimeter wave (mmWave) multiinput multi-output (MIMO) channel estimation. Existing methods either…
Consider a sensor network made of remote nodes connected to a common fusion center. In a recent work Blum and Sadler [1] propose the idea of ordered transmissions -sensors with more informative samples deliver their messages first- and…
In this paper, we propose an oversampling based low-resolution aware least squares channel estimator for large-scale multiple-antenna systems with 1-bit analog-to-digital converters on each receive antenna. To mitigate the information loss…
One-bit compressive sensing has extended the scope of sparse recovery by showing that sparse signals can be accurately reconstructed even when their linear measurements are subject to the extreme quantization scenario of binary…
In a wireless sensor network, data from various sensors are gathered to estimate the system-state of the process system. However, adversaries aim at distorting the system-state estimate, for which they may infiltrate sensors or position…
This work theoretically studies the problem of estimating a structured high-dimensional signal $x_0 \in \mathbb{R}^n$ from noisy $1$-bit Gaussian measurements. Our recovery approach is based on a simple convex program which uses the hinge…
Emerging wireless communication systems will be characterized by a tight coupling between communication and positioning. This is particularly apparent in millimeter-wave (mm-wave) communications, where devices use a large number of antennas…
Multi-antenna (or MIMO) processing is a promising solution to the problem of jammer mitigation. Existing methods mitigate the jammer based on an estimate of its spatial signature that is acquired through a dedicated training phase. This…
Security attacks at the physical layer, in the form of radio jamming for denial of service, are an increasing threat in the Industry 4.0 scenarios. In this paper, we consider the problem of jamming detection in 5G-and-beyond communication…
In this paper, we address the problem of target detection in passive multiple-input-multiple-output (MIMO) radar networks. A generalized likelihood ratio test is derived, assuming prior knowledge of the signal format used in the…
Coarse quantization at the base station (BS) of a massive multi-user (MU) multiple-input multiple-output (MIMO) wireless system promises significant power and cost savings. Coarse quantization also enables significant reductions of the raw…
Massive multiple-input multiple-output (MIMO) systems have attracted much attention lately due to the many advantages they provide over single-antenna systems. Owing to the many antennas, low-cost implementation and low power consumption…
We present a novel scheme allowing for 2D target localization using highly quantized 1-bit measurements from a Frequency Modulated Continuous Wave (FMCW) radar with two receiving antennas. Quantization of radar signals introduces…
This paper considers a nonlinear multi-hop multi-user multiple-input multiple-output (MU-MIMO) relay channel, in which multiple users send information symbols to a multi-antenna base station (BS) with one-bit analog-to-digital converters…
Jamming attacks can significantly impact the performance of wireless communication systems. In addition to reducing the capacity, such attacks may lead to insurmountable overhead in terms of re-transmissions and increased power consumption.…
We study multi-user massive multiple-input single-output (MISO) systems and focus on downlink transmission, where the base station (BS) employs a large antenna array with low-cost 1-bit digital-to-analog converters (DACs). The direct…
In this paper, we investigate a trade-off between the number of radar observations (or measurements) and their resolution in the context of radar range estimation. To this end, we introduce a novel estimation scheme that can deal with…
Millimeter wave (mmWave) and terahertz MIMO systems rely on pre-defined beamforming codebooks for both initial access and data transmission. However, most of the existing codebooks adopt pre-defined beams that focus mainly on improving the…